Jump to content

Wootdog

Members
  • Posts

    22
  • Joined

  • Last visited

Vehicle Info

  • My Car
    1971 Mach 1
    1967 C10 Step side
    1979 Z28
    2002 Silverado LT

Location

  • Location
    Virginia Beach, Virginia

Wootdog's Achievements

Apprentice

Apprentice (3/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. Not to muddy up the water, but it you were to look up on Power Nation dot com. The TV show is horsepower. you should be able to lookup the 351 Cleveland 2v versus 4v rebuilds they did with junkyard engines a couple of years ago. They actually generated more horsepower with a 2v than with a 4v. something to look into before you dump all that cash into a change so to speak. Just trying to help out a fellow member. Wootdog in Virginia Beach, Virginia.
  2. Engine wiring harness if not too messed up. All engine to the connector that goes to the tach dash? I already have a tach, just not the correct harness. I have a 71 not a 73. The 71 harness is different than a 72 slash 73 and so is the connector that goes to the gauge assembly. Kerry in Virginia Beach, Virginia.
  3. All, My fuel gauge stopped working so I went to the source and found out the connector that goes to the sending unit is in need of replacement. I can not seem to find one anywhere. Any help would be appreciated. It just plugs on the sending unit connector in the bottom of the tank. I have jerry rigged it at this time. Thanks, Kerry in Virginia Beach.
  4. Here are some pics. hard to do with as short as the wires are.
  5. Sorry guys for not updating sooner. I went back to work after the holidays and have not messed with it anymore. It only has two wires at the back of the engine one has power, the other does not. I will see if I can get a pic tomorrow before it gets dark. they are funny looking plugs. I have put in new Orings and hooked all the lines back up. If I stay with R12, I should not have to replace the drier correct? Kerry
  6. All, All I see is a Red and a Black wire together. The other three are on a 3 plug connector. I have those for temp gauge, oil gauge, and I believe distributor. (I have not looked at these In a while). As far as the A/C goes, this car at one time prior to my owning it had A/C. I ended up leaving the original heater slash A/C assembly and blower in it. Now I need to find some O rings for the lines. Then I will see it if will hold a charge. I have a friend that does A/C charging. Thanks, Kerry
  7. All, I recently bought a stock A/C System off one of the members here. The question I have is where the Compressor black wire hooks to under the hood. I see on the back of my engine, two wires with the same weird looking plastic connectors. One is Red and One is black. The Black wire hooks to another black wire that has the same funny looking plastic connector. I have never seen connections like it. It reminds me of a fiber optic connection. The Red one has 12 vdc on it at all times. The black one has no power at all. The air conditioning has not been charged yet if that matters. I believe it does. The setup is a 71 Mach 1 with the 351 Cleveland engine. I am going to change out the heater and A/C assembly and blower assembly this afternoon. I also will probably need to determine where the two vacuum lines come through the bulkhead connector also. The gentleman I bought it from does not remember how the black wire was hooked up. Thanks in advance. Kerry in Virginia Beach.
  8. Do you have pictures? What would shipping be to a residence 23462? Thanks, Kerry my email address is wootdogvb@gmail.com.
  9. Mike, check your Pay Pal account. It was painful trying to pay for the intake outside the US. They have thank goodness serious security. To get the transaction to work, I had to call Pay Pal direct. Sincerely, Kerry
  10. Mike, Will a Holley 600 CFM carb bolt up to it? If so, and you have not made a deal with anyone else I need your Pay Pal information. Sorry I have not responded. I am in Canada on business. Sincerely, Kerry in Virginia Beach New email address is wootdogvb@gmail.com
  11. 351 4V or 351 2V? Thanks, Kerry in Virginia Beach, Va.
  12. Will this fit a 351 Cleveland 2V? Or just a 4V? Thanks, Kerry in Virginia Beach, Virginia 23462.
  13. All, I need the Air Breather in Aluminum with the Script Ford Motorsport. Thanks, Kerry In Va Beach, Va.
  14. If the person in front of me does not want them I do. Price with shipping to 23462, a home not a business. Virginia Beach Virginia. How would you want paid? Thanks, Kerry wootdogvb@gmail.com
×
×
  • Create New...