Jump to content


  • Posts

  • Joined

  • Last visited

Vehicle Info

  • My Car
    1971 429scj


  • Location
  • Region

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

bdietz's Achievements


Contributor (5/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges



  1. Does anyone know how to restore the frosted look on the exterior door handles. Mine are worn off.
  2. I need the window channel trim moldings if they are in good condition, not the drip rail moldings.
  3. I see some chrome pieces I don't know exactly what you have there but I need the Mach 1 lower chrome body trim, that runs just above the bottom black out
  4. I picked up a black J code a few years back from the west coast, but it has a black interior and was an automatic. Original sold in Washington, but I found a speed shop receipt under the carpet from the early 80's from a shop in California.
  5. you are correct. I just purchased them and they do not fit. need to return them this week.
  6. AC Delco, re manufactured, starter part no. 336-1789, brand new never used. $40 plush shipping
  7. Competition Engineering drag shocks part no. C2740, brand new, never used. $75 plus shipping
  8. I have Energy Suspension sway bar bushings for sale. New never used. 3/4" greasable, polyurethane, sway bar bushing set in red part no. 9.516R $15.00 plus $7 shipping Sway bar end link set part no. 9.812R $15.00 plus $7 shipping. I'll combine shipping if you buy both
  9. What would be factory correct for the "429 ram air" on the hood, decal or paint? I see Graphic express sells the decal as well as a stencil.
  10. I read on the 429 Mustang and Cougar Mega site that the engine bracket that mounts to the frame is a little bit taller then one for a 351c, but they don't list any dimensions. Form the picture it looks to be about a 1/2" or 3/4" difference. It states "The top surface of the 351 frame mount is just a little bit taller than the 429 frame mount. This taller height will prevent the 429 insulator from dropping down far enough to properly line up with the thru-bolt holes". I have an original 429 car that came with a 351c. Now I am getting ready to put a 429 engine in it. I have the motor mounts that came with the car, but I don't know if they are 351c or 429. Can someone measure the height of their mount either a 351c or a 429. That way I would know what I have. thanks
  11. Anyone try the progress coil springs? I have a big block and am thinking about it?
  12. Looks like that is what I need to buy. thanks
  13. I dismantled my car and didn't take pictures before hand. I am installing the wiring harness in the engine compartment and I need help. Can some post pictures of how the wires get routed through the radiator support and head light buckets for the sport lights, side marker lights and lower valance lights. Also, how the harness wraps around/under/through the battery tray on its way to the starter solenoid? thanks
  14. Thanks to all. I am getting mine painted, should I use semi-gloss or a satin finish
  • Create New...