Jump to content

Robert sneed

Members
  • Posts

    16
  • Joined

  • Last visited

Vehicle Info

  • My Car
    73 mach 1 351 c 2v

Location

  • Location
    Wv
  • Region
    East

Personal Information

  • Sex
    Undisclosed

Robert sneed's Achievements

Apprentice

Apprentice (3/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

0

Reputation

  1. It’s a factory alt, but there’s no dummy light
  2. I have a 3 wire alt, and recently upgraded my wiring harnesses with a kwikwire wiring harness. Im stumped with this alt hook up not charging. This is how it’s hooked up, does anyone notice anything wrong? Thanks in advance.
  3. I just put a kwikwire wiring harness in my mustang. My left turn signal works as it should as well as my hazard lights, but when I use my right turn signal my head lights flag as well. Any ideas on what it could be?
  4. I just put a kwikwire wiring harness in my mustang. My left turn signal works as it should as well as my hazard lights, but when I use my right turn signal my head lights flag as well. Any ideas on what it could be?
  5. My brake pedal is almost stuck to the floor with about 3 inches of play when I press down. Any suggestions to get it to return? I just replaced my master cylinder.
  6. It’s pretty tight in there, I put a 5/16 socket on it didn’t feel right turning.
  7. Thanks for all the info, so you guys think this is normal even tho it’s stuck against the side like that?
  8. pulled my distributor and my rod started to come to then fell and some how got lodged any tips for getting it out? I tried a magnet and it wasn’t strong enough and pliers wouldn’t grip it.
  9. I’m in another pickle and was seeing if you guys could help me out. I finally got my new wiring harness installed, when I start my car it fires right up, however soon as I release the key it dies. I’ve adjusted my ignition switch back and forth with no luck. Would you guys happen to know of a quick fix or solution before I buy a new ignition switch? Thanks in advance.
  10. Yes it’s the curved connector but no wiring diagram shows wha each individual wire goes to, my new wiring harness isn’t the same colors as my turn signal switch
  11. I recently bough an aftermarket wiring harness, and have ran into some problems with wiring the turn signal switch into it. Ive searched all over the net and have ordered a few different wiring harness diagrams but havnt been able to find what i need. Would anyone know the color codes or which wire runs to what from the turn signal switch? Thanks in advance.
  12. Ii just dropped a new engine in my 73 mustang, it ran fine last night but today soon as I let go of my key my engine dies. Also now my key is stuck, any ideas?
  13. 351c 2v edelbrock performer intake 150 plus shipping Comp cam xe284h with lifters brand new 200 plus shipping 3/8 push rods 8.400 length 100 plus shipping text 3043775598 May do some trading let me know what you have
  14. Could be, I'll get my voltage meter out tomorrow and check it out
×
×
  • Create New...