Jump to content

cuedog10

Members
  • Posts

    25
  • Joined

  • Last visited

Vehicle Info

  • My Car
    1972 Mustang Mach 1

Location

  • Location
    Tennessee
  • Region
    South

cuedog10's Achievements

Explorer

Explorer (4/14)

  • First Post
  • Collaborator
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

1

Reputation

  1. I have a 351C with an Edelbrock intake and 600 cfm carb. It has a comp cam, 32-224-4. .519/.224 intake and .519/.224 exhaust with electronic ignition and 40000 volt Pertronix coil. Can anyone tell me the timing should be? Thanks in advance.
  2. I Used a simple 9 volt battery and two leads. Had no problems and I did not burn out the lights. if you have LED's, I used the same 9 volt and extended the small wires off the bulbs and touched the contacts. you may have to switch the wires around from the battery posts, as it will only light one way. that's the simplest way I found. Thank You
  3. Can anyone tell me how to check my dash lights while I have my dash on the work bench? Proper voltage and where to ground. Thanks
  4. I replaced the headlight switch too, forgot to mention.
  5. 1972 mach 1. Instrument panel lights went out. I replaced the fuse, the printed circuit, the bulbs and the in dash voltage regulator. I checked all my connections and they were good. The dome light went out at the same time. Ideas? Thanks
  6. I have a dist. with an electronic ignition. I need 12 volts during cranking and after starting. I want to be able to start the engine as well as turn the engine with the key.
  7. I need a 12 volt constant going thru the key switch. Does anyone know which wire I need to use? 1972 Mach 1. Thanks
  8. SB Ford 351C 351M 400M Small Cap HEI Electronic Distributor Ready To Run 1970-79 and a 45000v coil. The distributor has a red and a black wire. Can you tell me how to wire this setup? Dist to the coil, power supply and anything else that I need to know. I ran 12v constant and the red dist. wire to the pos. side of the coil and the black dist. wire and the ground wire from the solenoid to the neg. side of the coil. When I try to start the motor I have power on both sides of the coil but nothing to the distributor. Thanks
  9. Did it not come with some sort of directions or manual? If it's the one I'm thinking it is, send it back now. https://swperformanceparts.com/R2R6706BL/?gclid=Cj0KCQjwivbsBRDsARIsADyISJ_ijKWgiJ5uMuuXliVfFtm1hg9IAywzoc4EytGrok6fYJpKJ1nvB2gaAg92EALw_wcB I bought one of this type off Amazon, just to see how bad it was. Not only did it arrive damaged, it was one of the biggest POSes I've ever held in my hands.
  10. Alright guys, I sent all the Gm stuff back. I got a SB Ford 351C 351M 400M Small Cap HEI Electronic Distributor Ready To Run 1970-79 with a 45000v coil. The distributor has a red and a black wire. Can you tell me how to wire this setup? Dist to the coil, power supply and anything else that I need to know. Thanks
×
×
  • Create New...