Jump to content

Gregaust

Members
  • Posts

    33
  • Joined

  • Last visited

Vehicle Info

  • My Car
    67 Falcon ute
    67 Mustang project

Location

  • Location
    Australia
  • Region
    International

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Gregaust's Achievements

Apprentice

Apprentice (3/14)

  • First Post
  • Collaborator
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

6

Reputation

  1. What was the converter to flexplate clearance? Did you replace the flexplate and by chance get a C6 one ? They are different .
  2. Linkage - Manual Control Assembly - C-6 for 1967 Mercury Cougar, 1968 Mercury Cougar, 1969 Mercury Cougar, 1967 Ford Mustang, 1968 Ford Mustang, 1969 Ford Mustang, Other Ford/Mercury at West Coast Classic Cougar :: The Definitive 1967 - 1973 Mercury Cougar Parts Source (cougarpartscatalog.com)
  3. Linkage - Manual Control Assembly - C-6 for 1967 Mercury Cougar, 1968 Mercury Cougar, 1969 Mercury Cougar, 1967 Ford Mustang, 1968 Ford Mustang, 1969 Ford Mustang, Other Ford/Mercury at West Coast Classic Cougar :: The Definitive 1967 - 1973 Mercury Cougar Parts Source (cougarpartscatalog.com)
  4. If you need floor shift there is a repro ??? Linkage - Manual Control Assembly - C-6 for 1967 Mercury Cougar, 1968 Mercury Cougar, 1969 Mercury Cougar, 1967 Ford Mustang, 1968 Ford Mustang, 1969 Ford Mustang, Other Ford/Mercury at West Coast Classic Cougar :: The Definitive 1967 - 1973 Mercury Cougar Parts Source (cougarpartscatalog.com)
  5. https://secure.cougarpartscatalog.com/69-70c-6arm.html
  6. Yes they are https://secure.cougarpartscatalog.com/69-70c-6arm.html
  7. If a street type tread , likely a 20 will do .. I have found a 275/60 drag radial a little taller than a street tyre and is best with 21
  8. 1/4-28 is the thread for fitting into case , the 5/16 inverted flare !/@-20 is the fitting for the line into the fitting
  9. Yes you will . Depending on tyre size a 20 or 21 for auto , manual may be bit different
  10. What sort of rebuild was it ? Was it built right or just new parts thrown at it with no other measuring or checks ? Was the valvebody aligned correctly when fitted ? Were any bushes changed ? Endfloat checks ? Clutch clearances ? Band adjustments ?
  11. As suggested . mark the nut prior to removal , retighten up to just past the marks is the safest
  12. Yes . Does the kickdown lever feel ok and spring back if moved ? The valvebody will need to be loosened , then locate the selector. On a C6 you can see up in therewith the pan off. It can be tricky to get the valvebody in to line up both the manual valve and kickdown as the valvebody is located and bolts started
  13. There is a one piece seal available also . From memory Jon Kaase sells it . It takes a single cut so as to slip it over the crank to fit .
  14. Sure sounds like the valvebody and manual linkage not aligned right . Can be tricky if you've not done it before . Need to get the manual valve in right , also the kickdown needs to slot into position at the same time
×
×
  • Create New...