Jump to content

73FastBk

Members
  • Content Count

    54
  • Joined

  • Last visited

  • Days Won

    1

73FastBk last won the day on December 21 2020

73FastBk had the most liked content!

Community Reputation

12 Good

About 73FastBk

  • Rank
    Mustangs are cool

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Thank you very much, I will look at those options before having to tear it apart. I just want to make sure I do everything else before pulling the engine out. Thanks again
  2. Here the quick back story Back in 2003 my dad and I bought a used 351C and had it completely rebuilt. I was planning on swapping out the 302 for the 351 in 2004 but I ended up going to college and life got in the way. Fast forward till now.... I took the car to the shop for the swap which included the c6 Tranny. The engine idles perfectly fine and starts right up. but... once you turn it on, it starts blowing blueish smoke on the left exhaust (no H pipe) It takes about 1 minute warming up before it blows smoke. Do y’all think it’s the valve stems? I figure they might have dri
  3. Looking for Mach 1 hood, prefer oem but if also willing to get repo if needed if y’all have any recommendations.. thanks!
  4. Definitely do you measurements but I think 9.5 should be a better option. You will avoid banging the wheel well
  5. If you’re going 10 wide. I’d look for 6 -6.5 backspacing. That 5.5 will be tight
  6. Yes I used a sander with 100 grit to sand off any bubbling or high spots. After I Added 2-4 coats of jb weld. Sanded with 200 then 400. That was it. Fairly easy tbh
  7. You can pay someone to vinyl wrap them. What I did was sand the area down for prep and added a few layers of Jb Weld and then sand it until it’s smooth. Then ordered paint from cjpony that matched and painted it. Looks good as new imo.
  8. Last finished photo, installed and painted dark ginger.
×
×
  • Create New...