Forum News
Search the Community
Showing results for tags 'Sold'.
Found 5 results
-
Hello, I recently scored a Tach Dash and triple gauge cluster at a swap meet. I am looking for the correct dash harness for them. I really don't want to hack up my original stuff to make them work. Thanks. EDIT: My bad, I did not see the Want To Buy forum, I thought this was it
-
These are the seat belts that came in my car. Based on the tags they are from late 1970. The pictures show the tags. $40 (OBO) + shipping -
Selling my 1971 CJR 429 Ram Air (J-code) Mustang Mach One (05) Automatic, A/C, power disc brakes, power steering. Car needs full restoration, but is very complete. Car had not run in many years, and I am slowly bringing it back to running and driving condition. Engine runs well, transmission was rebuilt by previous owner and it shifts good. Power disc brakes just repaired and also work well. Non original 1970 429 is installed with C-6 trans. Solid floors, frame rails are good, will need trunk floor and right rear trunk floor extension. Rust repair needed under batt -
Restored this about 2 years ago. Wheel had a lot of cracks I ground out and used PC-7 to fill. Painted with appliance epoxy paint, horn contacts are good. Not concourse condition but it’s also not 450 bucks. 125 shipped. thanks for looking.
-
I am selling this kit that I bought from CJPony Parts at the end of 2014 (https://www.cjponyparts.com/rear-disc-brake-conversion-kit-small-bearing-8-9-1965-1973/p/DBR21-V/). I bought the DBR21, but now they listed as DBR21-V. I understand they have redesigned the calipers since I bought this kit. You will get pretty much everything in the kit listed plus one extra caliper, extra set of pads and extra hardware that I used to install it in my Mustang. I have 3 calipers because the kit I bought had two matching calipers so one side can be installed in the oposite orientation, which will have
-
Google Custom Site Search