naa10104
Well-known member
- Joined
- Jul 26, 2014
- Messages
- 446
- Reaction score
- 1
- Location
- Reston, VA
- My Car
- 1973 Convertible, matching #'s H Code, Auto
So I get in my Mustang this AM early to go get a front end alignment. Car spent it's first night outside under a cover in 31 degree weather ... it is usually in a garage. At any rate I open the car get in the drivers seat and immediately notice that a motor is running in the back seat area, could only be the convertible top pump. It stops after 5 - 10 seconds. I put the key in the ignition and turn it to start, absolutely nothing, no clicking of any kind, nothing. Just the idot lights come on. I do this several times without success. Pop the hood check the terminals which are tight, knock on the ignition relay(?) I think, round black plastic switch next to the voltage regulator. Get back in the car still nothing, try half dozen times. I then gently push the gear shift lever(auto on floor) forward just in case. It moves maybe an 1/8th an inch. Not enough in my mind to be a problem. The car starts fine on the next try.
I should mention that about 2 weeks ago I noticed some issues that I believe are related to the voltage regulator, but have not sorted them out. Basically, fuel gauge started to drop and then heard a click and the alternator idiot light flashed once and then gauge climbed back to appropriate position. Was told this is probably regulator. Also, occasionaly get a rapid clicking from the seat belt sensor switch under the driver's seat.
Would appreciate any suggestions on these issues ..... thanks in advance !
I should mention that about 2 weeks ago I noticed some issues that I believe are related to the voltage regulator, but have not sorted them out. Basically, fuel gauge started to drop and then heard a click and the alternator idiot light flashed once and then gauge climbed back to appropriate position. Was told this is probably regulator. Also, occasionaly get a rapid clicking from the seat belt sensor switch under the driver's seat.
Would appreciate any suggestions on these issues ..... thanks in advance !