Took about 3 1/2 hours motors in and most accessories are on. Will finish assembly and be cranking tommorrow. Dropped right in and was easier then pulling.
Motor's back in. Installed sheild and reinstalled motor. Back out..Back in....but my back is out. Just need to add some fluids, get a new battery and new cables and I'll be ready to fire up.
Forged flat top pistons,Comp Cam Xtreme Energy XE262H, Edelbrock Performer Intake and 600CFM-4V Carb. 2200 stall, 2.79 open No Headers Not sure what HP I'm pushing, but sure It's enough for a weekender.
Don't feel bad, I had my motor in and out a couple of times also, only one time was a killer when I didn't get the tranny fully seated and blew out the pump. That was a costly error........I'll never make that mistake again!