Jump to content

engine issues?


Recommended Posts

If you do not mind, my Cleveland as upgraded w/solid lifters w/H.O. Lunati cam and 9.5 compression, and only 2800 miles after the overhaul as well w/the Ford toploader but for some reason, and issue arised with oil pressure increasing immensely since AC after market 'Hurricane' installed, some squealing of belts though oil looks clean, w/couple of years on it, think the viscosity has broken down however did run into a little hiccup with running an attempt in a 1/4 mile but did not change gears from 1st to 2nd until it reached, 58mph w/7200 rpms and 'what a backfire from it. Not a noticeable leak from anywhere however looking at taking it in for a gasket refitting. and maybe rear end seal needing attention a little bit. what do you think(possibly a clogged pick up)? not too experienced at this........<:+?> "Think I will have it towed from place where look into belts and then over to have engine gasket fixed

then amidst change over from 2 barrel intake manifold to a 4 barrel 'air gap' to replace it then that XADO additive into the 'soup', ;per se.

1_12_09_14_11_07_03.png
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...