pertronix power relay

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Made my own using same setup. 10 years still works fine

 
i never thought of doing this.. i just used the resistor wire voltage to the coil with the pertronix. it runs fine, but i may just used a relay and do the same thing.. i have a relay so it's cheaper then buying .

 
I put one in. No issues, easy as pie. Directions were spot on. Using the relay with a Pertronix III. I mounted the relay on the passenger inner fender near the voltage regulator.

 
Last edited by a moderator:
the pertronix power relay generates a full 12v to the coil for use w/ elecronic ignition and avoids messing with the pink wire. if anyone has installed this item http://www.pertronix.com/docs/instruction-sheets/0000-008770.pdf

let me know if you had any problems.
I thought you were going with a Duraspark set-up using the NPD conversion wiring harness. If that's the case, the Pertronix power relay is not necessary. Trust me, I'm running an Accel Supercoil with the Duraspark & NPD wiring harness - no issues.

 
Back
Top