Jump to content

Interior clock


Recommended Posts

Is it anyone that have had problems with the clock in the console. The pin to adjust the time is loose. Can`t adjust the clock to the right time. Is it possible to fix and how?

212544263_DSC_2331utg2.thumb.JPG.1324af48b0ad25ee5da5c78491f0539e.JPG

Link to comment
Share on other sites

The set shaft is held in by a small gear that is pressed onto the end.

In between the gear and the backing plate inside the clock there is a small spring and washer.

All three pieces should be floating around inside the case - don't lose them when you take it apart.

Bob

 

Tachs, Voltmeters, Headlight kits, Wiper delays and more at

http://www.rccinnovations.com/Images/smlogo.jpg

Rocketman's Classic Cougar (and Mustang) Innovations, LLC

 

Link to comment
Share on other sites

83241908_DSC_2332utg2.thumb.JPG.5374049b8923d8a7fdb1507509bff5ed.JPG

TheRktmn pid='332468' dateline='1541096870']The set shaft is held in by a small gear that is pressed onto the end.

In between the gear and the backing plate inside the clock there is a small spring and washer.

All three pieces should be floating around inside the case - don't lose them when you take it apart.

 

If got them...Where shall the washer be mounted on the axle? Gear wheel?  Which end of the gear wheel shall it be on the axle?

Link to comment
Share on other sites

The set shaft is held in by a small gear that is pressed onto the end.

In between the gear and the backing plate inside the clock there is a small spring and washer.

All three pieces should be floating around inside the case - don't lose them when you take it apart.

 

If got them...Where shall the washer be mounted on the axle? Gear wheel?  Which end of the gear wheel shall it be on the axle?

 

 

2018-11-01-16-27-44.jpg

 

The washer goes between the spring and the gear.

 

When you pull on the shaft to make sure the gear is secure, aim it into a small cup to catch the gear, washer and spring if they weren't secure.

:whistling:

 

I have had the best success with 'peening' the end of the shaft.

Bob

 

Tachs, Voltmeters, Headlight kits, Wiper delays and more at

http://www.rccinnovations.com/Images/smlogo.jpg

Rocketman's Classic Cougar (and Mustang) Innovations, LLC

 

Link to comment
Share on other sites

  • 2 months later...

Not sure if this is too late, but sent my center clock out to a company in Illinois for repair.

The cost was about $115 and it came back in perfect factory condition.

you can also ask for the clock to be changed to quartz.

Took about 3 weeks. They even buffed out the scratches on the lens.

 

Their web link is below.

 

www.clocksandgauges.com

 

Dan

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...