- Joined
- Nov 7, 2013
- Messages
- 1,594
- Reaction score
- 286
- Location
- Amsterdam, The Netherlands
- My Car
- 1973 Mustang Grande 351C 2V, built on the very last production day (July 6, 1973) for Grande's.
Hey folks,
The tip of the inner edge on my LH quarter panel is somehow pointing inward too much. You can see it bending inwards too much when looking at it. So I'd like to correct this. In the included picture I've tried to show it, basically the red line should be corrected back to the purple line.
What's the best way of doing this? Heat it up and hammer it back? This is my first time doing sheetmetal work, any advise is welcome
Cheers,
Vincent.
The tip of the inner edge on my LH quarter panel is somehow pointing inward too much. You can see it bending inwards too much when looking at it. So I'd like to correct this. In the included picture I've tried to show it, basically the red line should be corrected back to the purple line.
What's the best way of doing this? Heat it up and hammer it back? This is my first time doing sheetmetal work, any advise is welcome
Cheers,
Vincent.