Any pictures of 71’ 351C engine harness?

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Jan 17, 2015
Messages
1,766
Reaction score
601
Location
California
My Car
71' Grande project.
71’ 351C car.

I can’t figure out how the heck the factory engine harness lays.  
 

Looking at the 72 diagram it seems like it should follow the drivers side valve cover. 
 

The “gotcha” seems to be the oil pressure wire which has to go to the sender in the center rear of the valley.  The short white wire with red trace is that wire.  
 

It almost appears like the harness crossed the rear of the engine and went forward on the passenger side valve cover.

Any help is appreciated (but good help is really appreciated!)

image.jpg

 
Here is my 351C 2v with A/C. The harness runs down the drivers side. I don't see the electric choke wire with the square plug on your harness or the plug for the carb curb idle solenoid. The last picture shows the single white female plug for the PRDL light (if I recall correctly) which runs down the firewall and down the trans tunnel.  I think your white male plug in your picture is incorrectly part of engine harness.

20170309_120341.jpg

20170313_163556a.jpg

20150525_144857.jpg

20160820_151338.jpg

 
Last edited by a moderator:
Back
Top