Jump to content

Repop deluxe dash panel - how did you secure it? (They made the mounting posts smaller)


Go to solution Solved by Bentworker,

Recommended Posts

Anybody have any advice on how to the repop deluxe dash parts?  The hollow pins that are cast into the part for the nuts are about .320” which seems to be too small.  The securing nuts just slide over them.

 

 

050018D6-35E8-4723-B10A-DA38E6408635.jpeg

Link to post
Share on other sites

I might have a solution inbound- McMaster-Carr had self threading nuts for 5/16” rod.  If it works out I’ll have plenty for anyone else who runs into the same problem 90533A140 was the part number I ordered.

Link to post
Share on other sites

Let us know how they work out... been looking for a good alternative

For the smaller screw holes heat up the screws and use candle wax to lubricate the threads so you don't snap off the plastic studs

Not sure if that will work for the larges studs

 

 

Ohio Mustang Supply

440-949-2556

 

http://www.7173mustangs.com/images/oms_sig_banner.jpg

Link to post
Share on other sites

I picked up a set from Lowes.  They were a little tight so I took my time and thread them on and off a little at a time several times to cut threads into the plastic.  I do believe they were the following.

https://www.lowes.com/pd/Hillman-5-16-in-x-18-Zinc-Plated-Steel-Hex-Nut-4-Count/3013165

Kilgon

 

 

"The only dumb question is the one not asked"

Link to post
Share on other sites

I’ll be sure to update you all once the nuts show up. The CAD drawing of the McMaster part looked very similar to what Kilgon posted.  
 

I also measured the holes for the glove box door trim and ordered some screws from McMaster that may fit the aftermarket part a little better.

We’ll see next weekend!

 

I’m getting dangerously close to getting the dash in!

 

Link to post
Share on other sites

I found a multi-pack of the sheet metal speed nuts at local auto parts store and it had the right size to bite the studs. And I drilled out the holes that take the screws so the factory screws would actually fit them, then I used wax on the screw threads so they went in easier. If you notice, the holes in the plastic studs are actually slightly different sizes, so you will never get all the screws in without problems. Thats why I drilled them all to the same size. It doesn't take a lot of thread bite to hold the panels. Good luck!!

Link to post
Share on other sites
  • Solution

Well- the self 5/16” self threading nuts worked.  A little tight for my taste so I took a chainsaw file to them to remove a little material.  I ended up drilling out the screw holes a bit as even with the slightly smaller screws I got from McMaster I was still a little uncomfortable with the fit.

 

 

5DD45EF7-493B-40BE-A2E5-5AE8E7FF18F3.jpeg

Edited by Bentworker
  • Like 2
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...