Jump to content

My 9 inch pinion seal was leaking. I marked the pinion and the nut and removed the seal

Recommended Posts

The odds are 99.9% you have a crush sleeve unless someone replaced it earlier with a spacer.  Don't know if you took a preload reading before you took it off. You need to get it back to the exact spot it was at.  See the link below. Scroll down to the section where Don C posted a section of the manual on how it should be done.


Edited by Kilgon




"The only dumb question is the one not asked"

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...