Jump to content

Can I plug heater core line outlet and return pump and intake?


Recommended Posts

I'm trying to clean my engine compartment up some when I get this motor checked out back together and back in the car can I just plug the heater core Outlet on the pump and the heater core return on the intake manifold on my 429 or do I have to put a short Loop connecting the two of them so water still flows through there? I attached an image of the two holes. The more stuff I pull off this 429 the bigger it looks. The car is a garage princess I really do not need a heater core in it the one that's in the car now popped and I've already changed it twice I've had the car since 1985 so I'd rather just not have that heater core functioning and not have all the lines. Thank you for your assistance

20210624_163320.jpg

Edited by pposey
Link to comment
Share on other sites

if the engine has been installed with all the original goodies. On the back of the engine there is a vacuum line that is on the input line of the heater core (it shuts off the fluid under wide open throttle, I think). You need to disconnect that one as well and connect the vacuum line so there is no switch. 
This part is I think found 429 AC cars only.


vac-switch-polished.jpg

 

 

Edited by Fabrice

73 modified Grande 351C. (Finally back on the road woohoo!) 

71 429CJ. ( In progress )

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...