Jump to content

Help with wiper switch wiring


Recommended Posts

Hi

I need some help to where the wires go. I would like to set it up to test outside of the car.  

I have a remade cardone viper motor 4 wires.  red blue white black.

Battery
Hi motor
Low motor
Washer pump
Ground
Motor  power
Motor  Park
 

This is taken from backside of the switch could somebody just put the numbers on the right place.  Forget the old harness, think of new installation :-)

 

wiper.jpg.438668bfaf46acf09e828782b7833e68.jpg

Edited by Robsweden

For knowing your limit you have to pass it ::thumb::

 

Link to comment
Share on other sites

  • Robsweden changed the title to Help with wiper switch wiring
7 minutes ago, Hemikiller said:

Here's the pin out diagram from the diagrams. 

 

https://7173mustangs.com/wiki/

 

WIPER_SWITCH_PLUG.JPG.cd537b188b76a7babef3adb7a0f7d490.JPG

Thanks, but I dont have the orginal harness installed.  So I need to now how to connect it from scratch without the original harness. Ground , battery etc.

For knowing your limit you have to pass it ::thumb::

 

Link to comment
Share on other sites

I can add that the switch is a bit strange, if a wiggle it a bit between low and high I can make the wipers stop. Has it gone bad ?

For knowing your limit you have to pass it ::thumb::

 

Link to comment
Share on other sites

4 hours ago, Robsweden said:

Thanks, but I dont have the orginal harness installed.  So I need to now how to connect it from scratch without the original harness. Ground , battery etc.

 

Using the original diagram along with the pin out diagram will get you where you need to be. Connector C901 - the pinout diagram, is the switch itself. 

 

WIPER_WIRING.thumb.JPG.7321f493f571f0068adc365e22fe8352.JPG

  • Like 1

 

 

Link to comment
Share on other sites

As shown in the wiring diagram and pinouts, #1 in your picture is circuit 941, black with white stripe wire, runs to the windshield washer motor. #2 is circuit 297, black with light green hash wire, provides power to the switch for the motor, comes from the switch block. #3 is circuit 63, the red wire, runs to the red wire on the motor. #4 is circuit 58, white wire runs to the white wire on the motor.  #5 is circuit 28, the black with pink dots wire, runs to the black wire on the motor. #6 is circuit 56, the dark blue with orange stripe wire, runs to the blue wire on the motor. #7 is the white with purple wire, comes from the fuse block to provide power to the washer.

The wiper motor is grounded through the brass strap that connects to one of the mounting tabs.

  • Like 1

 

 

“If you can't explain it simply, you don't understand it well enough.”

--Albert Einstein

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...