I have a 71 mach1 with a 351 4v, c6 and 9 inch rear. I am looking to replace the drivers side axle. Would the axle be a 28 spline or 31? Any suggestions on where to get one at a decent price would be appreciated. Thanks Rick
All the aftermarket pieces are very soft. I recommend that you get black window sealer and glue it in place. Trust me, you will never install it without bending it. I hope you prove me wrong but I tried many times, even took it to local glass place . Good luck.
My right directional signal light inside the car does not always work. The signals outside work fine. I figure its a loose bulb , they were changed to led about 5 years ago. I am trying to get the bezel off and get to the bulb. It is fighting me and the problem is it is hitting the steering...
My wife's 65 convertible is pictured in the readers album section. They have me listed as having a 71 convertible but I actually have a Mach 1. Glad to be in it. I had sent the picture in at least 6 months ago and forgot about it so it was a surprise.
I had scratches on my rear and side windows and I only made them worse trying to polish them out. I took the car to a pro glass place and they could not get them out. I replaced the side rear window and I put louvers on the rear window because it has a rear defrost setup and I did not want to...
You guys are the best. I found a broken vacuum cap at the back of the carb. The best way to do it was with the propane torch. The carb cleaner is ok but it will take the paint off the motor.
Thanks again
The choke is working fine. I checked the vacuum and it was over 15 at the carb and over 20 at the manifold. I checked all the lines and everything is holding the vacuum except the ram air which leaks a little. I bypassed it but it did not make a difference. Any other suggestions?
Thanks
I have a 71 351 4V with a holley carb. The car has been running great for some time now. I went for a ride yesterday for about 1/2 hour. I stopped the car for about 5 minutes. The car was a little hard to start after the rest but would not idle. It kept stalling. I was able to make it home and...