Recent content by Butch65

Welcome to the family. Very cool your wife is one of the gang!

Welcome from GA!

DW- When we re-upholstered a couple years ago, we went with ACC foam and Distinctive Industries seat covers.  While they looked great, the foam density wasn't to my liking and didn't fill out the bolsters very well.  So after living with it ( and now that the son is in away at college- it's his...

Not sure that this should be in this forum or the Misc (not 71-73 specific) but I'll let our moderator decide.  :whistling: When we installed the Tremec it came with this shifter and it worked great. (The fellow I bought it from pulled the tranny out of his Eleanor). During my son's college...

Hey gang-  The garage clean out continues! Purchased these kits from Mustangs Unlimited back when they were here in Georgia.  After weighing options we decided to go with Steve's upgrade instead. 4 sets (4 pins, 8 bushings).   Let me know if you can use them and they are yours for the cost...

Started the day intending to play with different options for firming up the foam / spring supports of the driver seat.  We put new ACC foam in it when we had the seat covers replaced, but its always been too soft for me. After unwrapping and removing the foam, I found that the seat pan is in...

Thanks for sharing!  Love the wheel covers- and the interior!  Love to hear the story behind this one....

Looking Good, Capt! Good luck with the sale.

Hey gang, I have a like new AutoMeter model 5292 Hall Effect Speed Sensor left from the conversion to electronic gauges. Still in the original packaging with documentation. I found that I couldn't get it to fit on the Tremec 3550 due to the support castings around the speedometer port on the...

Mission accomplished ! Thanks for the responses.

Looking for a set (upper and lower) of 73 driver side hinges to rework with Steve's bushing kit.  Please respond via PM. Mahalo! Butch

Looking Good!!

Froggy- Ours entered service looking a lot like yours! We were actually looking for a Mach when we came across this one just a few miles from us, and after test driving with the top down we had to have it. Since we weren't going to have a Mach but still wanted that street fighter look, we...

I was too impatient to wait for the tool and found that I had a very large Phillips screwdriver that worked nicely. :P I padded the tangs of the end with a piece of painters tape to protect the hardware finish.  Worked like a charm.   Where did you find replacement bezels ?

I was too impatient to wait for the tool and found that I had a very large Phillips screwdriver that worked nicely. :P I padded the tangs of the end with a piece of painters tape to protect the hardware finish.  Worked like a charm.   Where did you find replacement bezels ?