Recent content by Cjmach1

Post a pic to me what your looking for

Hi if you want I can check should have a set for 73

73 Q code mach 1 c6 auto

Nice clean car Casey. Welcome to the forum

Do you have a pic what you hey look like. That why I can check

72 and 73 should be the same right

Your right,the repo panels are slightly off . Not all holes just a few. That were like I was saying on the repo door panels I just lined up and made the black piece that the clip fits in a bit bigger to which way it had to line up and it worked great. No issues

What I did was used a small rotary drill with a bit and slightly made the hole that the clip fits in a bit bigger to whatever side the hole on the door lines up to.worked well for me

Hi scubaman, I couldn’t fine any for mine so found some mactac on Amazon and used my old one as a template. Worked out good mactches the wood grain on the side panels on the door great.

Hi Stanglover where in Canada are you located,I’m in manitoba

Thanks for all your help,yes yellow I knew it attached under the shock brace but wasn’t sure from there and no schematic I looked at told me where it went. Thanks again was a great help

hi from Canada, can anyone tell me where the rear window defrost wire hooks to under the hood. Thanks

73 mach 1 Q code 351 cj with c6 auto trans 2800 stall, and a shift kit

Hi joe sent me a email at [email protected] I have a coupe parts car with the chrome for vinyl.

It’s usually the cowls they are usually rusted around the lip. So instead of water going around the raised lip it goes into the cowl and on your floor