Recent content by cuedog10

Thanks to everyone.

I have a 351C with an Edelbrock intake and 600 cfm carb. It has a comp cam, 32-224-4. .519/.224 intake and .519/.224 exhaust with electronic ignition and 40000 volt Pertronix coil. Can anyone tell me the timing should be?   Thanks in advance.

Thank You

Can anyone tell me how to check my dash lights while I have my dash on the work bench? Proper voltage and where to ground.  Thanks

I replaced the headlight switch too, forgot to mention.

1972 mach 1. Instrument panel lights went out.  I replaced the fuse, the printed circuit, the bulbs and the in dash voltage regulator. I checked all my connections and they were good. The dome light went out at the same time. Ideas?   Thanks

I have a dist. with an electronic ignition. I need 12 volts during cranking and after starting. I want to be able to start the engine as well as turn the engine with the key.

Just with the key on.

I need a 12 volt constant going thru the key switch. Does anyone know which wire I need to use? 1972 Mach 1.   Thanks

No Instructions

 SB Ford 351C 351M 400M Small Cap HEI Electronic Distributor Ready To Run 1970-79 and a 45000v coil. The distributor has a red and a black wire. Can you tell me how to wire this setup? Dist to the coil, power supply and anything else that I need to know.  I ran 12v constant and the red dist...

That is the one.

Alright guys, I sent all the Gm stuff back. I got a SB Ford 351C 351M 400M Small Cap HEI Electronic Distributor Ready To Run 1970-79 with a 45000v coil. The distributor has a red and a black wire. Can you tell me how to wire this setup? Dist to the coil, power supply and anything else that I...