Recent content by Ja.mc44

This is just the simple diagram of what I have set to the car right now. What I tried today: 1. I pulled starter and bench tested it, solenoid activated and held constant 12V. Obviously not under load so I will have it load tested this week at auto parts store. 2. I took the battery off of our...

So this is what I'm running. Top black is Bat(-), Red goes to engine block, bottom black goes to starter mount. The common bolt is unpainted frame rail. I also took jump cable hooked it to negative on bat and to bolt on engine block to make sure there's a direct ground from bat to engine. Even...

Ahhh I do not have it grounded directly to the engine block! As of now I have the Battery (-) grounded --> Frame rail --> starter, and the engine grounded from the water/cylinder head pump bolt to the opposite frame rail. So they are both grounded to chassis but as separate circuits. Would this...

Battery ground is run straight to frame rail. What size wire do you use for solenoid to starter. I think the one on there now is like 6 gauge. Its not hot after cranking though. Its a very weird situation and Ive been troubleshooting it for weeks now to no avail. I ll take for a load test.

Hey Guys, 1973 351C - Car has new starter, new solenoid, new battery, all paired with MSD ignition box. I have 13.7 volts at battery with a jumper on it for extra power. The problem I have is when cranking the car falls from 14v to 9 on the battery and cranks extremely slow. Though when I...

Heys guys, My first engine rebuild, everythings together, wired up, I crank her over and Im getting no fuel to carb. I throw a gauge on the inlet side of pump and I'm getting almost no vacuum. Switch it over to outlet side, little more of a reading on gauge but not enough to make anything...

Yo guys, Is there really no manufacturer making replacement framerails for the 73 mustangs? I know there not popular but still. Thanks

I doubt anyone has a set of these laying around but I need 1973 driverside+passenger side doors and would rather not pay 700 a pop to get them off Cj's. Anyone know anywhere I can find some of these?

Hey Guys, I'm planning on replacing the driverside floor support on my 73'. Has anyone done this before, or know of a good build forum involving this? I need to cut open the bottom of the torque box in order to get out those spot welds holding it onto the frame, but if I do cut the torque box...