Recent content by Mach

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    1971–1973 new Chrome Ford Mustang Bumpers

    Any chance of splitting the set? I am only looking for the front bumper. When my motor was dropped in after rebuild, my bumper got scratched by the tranny. CJ has them for $105 shipped, but thought I would ask... John
  2. M

    Who can use my Junk?

    Guys, You will have to be patient with me. I am in Sales and it is end of month, end of quarter. The week following Thanksgiving, I am on Vacation for a week so will have time to get everything boxed up and will have shipping prices. Please make sure that you have sent me your full ship to...
  3. M

    Who can use my Junk?

    They are high priced...whatever shipping cost is to your address from Columbia, Mo. Does that seem fair? :D Update...Center Mini Console and Brake Fluid cover spoken for! and Tail lights, battery cable, brake cover, mini console,... Ok guys, I think most all is spoken for...thanks for...
  4. M

    Who can use my Junk?

    Hey Guys, Cleaning garage. Got some old, broken, and dirty stuff. Email me if you're interested. Price... cheap if any price at all. Just hate to throw stuff away that one of my brothers could use... Need $10 for Gauge pod. All other flexible. Gotta pay shipping of course but should not be...
  5. M

    Data Sheet for Shows

    Has anybody else done one of these for their cars at shows? People ask me what I have done on the car and I say...uhhh go read the sheet...:D Mustang Mach 1 Data sheet.pdf
  6. M

    Goals for the car???

    Gentlemen, I am getting really close to my goals on mine. I just finished with a new 351C block bored 30 over, flat head pistons, new cam, polished, balanced, new carb, new fuel pump, new oil pan, new this new that...then add a freshly rebuild and beefed up AOD transmission then move to...
  7. M

    Sound Deadener/insulation question.

    My personal experience was with damplifier and Spectrum. Amazing stuff. I did everything from the Firewall back to the rear tail lights with two/three coat of Spectrum and used Damplifier on the big metal areas. I used standard Damplifier and seemed to work well. Make sure to roll it down good...
  8. M

    speaker size and locations

    It is not what I would do. I opted for cutting the doors and found is not that hard. I would think mods under the dash would be MUCH more intrusive/difficult. Then again, if it is not viewable, it would not be a bad thing. I had a 6x9 hanging under my dash in my 72 when I was in HS. People...
  9. M

    Battery not charging...alternator/electrical help please!

    Don, Thanks for the reply. It seems that my new regulator I got from CJ's is a bit different than the Wells unit that was in the car. On the new one, pins 1 and 4 are externally shorted (as shown in picture) and seems that pin 2 is not connected to anything. My old one has some different...
  10. M

    more electrical problems

    CJ Pony Parts has just the sockets if that is all you need...
  11. M

    T-handle not locking between neutral and reverse

    Kurt, Racer X is correct. I am really familiar with mine and have had it apart a couple times...I will say there is an adjustment you can make to the tab that lifts when you press in the shift button, and it controls the travel of the tab that fit against the pawl. The other thing is that the...
  12. M

    Battery not charging...alternator/electrical help please!

    Hey Guys, While traveling to a show a couple weeks ago, my radio started acting funny. It would nearly go off then back on...then off and back on...once I got to the show, 80 miles from home, I drove to the lot boss and while talking my pony died, and would not turn over...The lot boss jumped...
  13. M

    My brothers...I need help...

    Hey Thanks! That is what I had no idea what it looked like...hahaha. I appreciate it!
  14. M

    My brothers...I need help...

    Guys I have no idea what this indicator / pointer/ whatever you wish to call it looks like. As you can see mine is broken off and I can't see what gear / position my auto stick is in. Does anybody have a pic of what it supposed to look like so I can fabricate something that looks similar...
  15. M

    1/18 scale diescast 71-73's & my Mach1

    I too just invested in an AutoArt yellow 1971 Mach 1. I thought to use for display at shows and am hoping that it would get nabbed.... The detail is amazing. I could not really afford it either but was just too cool to not have. Now to have a collection of these...THAT is some $$$...
Back
Top