Help Support 7173Mustangs.com:
-
-
MCall Cam Research. 303-762-0022 Camresearchcorp.com They specialize in fords
-
MAgree on this. The local guy that has built a few engines for me refuses to work on anything that comes in with their stuff. Local...
-
MNo way I would use one of their products
-
MSpeedmaster?? Like the Chinese knock off stuff? If so I would steer way way clear of that junk.
-
MYou might contact Brent here https://customfordcams.com/ he is ell connected at Comp and Bullit cams. Chuck
-
MLike TommyK mentioned there isnt much room above the tank in that spot. I went with a hyperfuel kit which is likely a little shorter...
-
Mmach72 reacted to tony-muscle's post in the thread What are my options Beyond Subframe Connectors? with
Like.
No mods to the car. I fabricated the cross-bar to fit around then engine and accessories. That's the advantage of DIY. MIke's... -
Mmach72 reacted to tony-muscle's post in the thread What are my options Beyond Subframe Connectors? with Like.
They don't make a lot of this stuff for 71-73 because of the small market size. Sometimes the best bet is to get something for a 70 in...
-
Mmach72 reacted to Neoconshooter's post in the thread Over nine years I had three 71-72 Mustangs, two boss 71s, one each 351&429, and a 72 351-HO. with Like.
No, as my fortunes rose and fell, I went through a Porsche 911 and the cost of getting it back into the states, two used 71-72 mustangs...
-
Mmach72 reacted to MAD IRISHMAN's post in the thread Old magazine articles on the new 351 Boss Mustang. with Like.
Found a couple of magazines from 1971 with articles about the new 351 Boss Mustang.
-
Mmach72 replied to the thread New member from Tulsa Oklahoma.The lower first and 2nd gear were never a problem at the track. I could sixty foot in the 1.6x 1.7 range.
-
-
MI went the same route w the converter on the C6 I had Broader performance re- stall the stock one. The flywheel looks much better than...
-
Mmach72 replied to the thread New member from Tulsa Oklahoma.I ran a C6 that I had put in the wide ratio 1st and 2nd gear, and also the roller bearing kit from Broader performance. Converter is a...
-
Mmach72 replied to the thread New member from Tulsa Oklahoma.3V 225cc 58cc chambers. Took 11 months to get them last April.
-
MYou can't beat a convertible for fun and excellent resale value. These 71-73 cars look like they make great convertibles. What a...
-
-
Loading…
-
Loading…
