Recent content by mbrew2

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. M

    sub frame connectors

    If you are thinking of lowering the car be cautious about installing the frame connectors. On my 73 vert I had installed eaton springs  1" drop springs. That drop with 225/60/15 BFGs on the front only left about 4" of ground clearance with the frame connectors in place. I really wanted Frame...
  2. M

    351C blocks for sale

    I have no interest in any of this stuff. Was just curious as to what value might be. I agree that if I needed a new engine, I would want to start with a clean, unmolested, block. This guy is asking $800 for everything but indicated he would accept any reasonable offer. It also occurred to me...
  3. M

    351C blocks for sale

    Fellow down here has 3 351C blocks that have been machined. 1-DOAE-J , and 2 - D2AE-CA. 1 bored .030, 1bored .040, 1 not sure. all 2 bolt mains. Also 1 set of 2v heads machined with new guides but no springs. Says he bought them out of a machine shop going out of business to keep them from being...
  4. M

    Here's a special ($$$$$$} one for you big block lovers

    https://www.facebook.com/marketplace/item/233683231260768/?ref=category_feed&referral_code=undefined
  5. M

    Need Carb Help

    Not a carb guru, but here's my advise from experience. My car had an eldelbrock 1406 on it when I bought it.  Thought it ran OK but had constant problems with running rich and bad heat soak when it got hot. Tried everything anybody suggested. Finally gave up and swapped it for a Summit carb with...
  6. M

    why am I blowing up ignition coils?

    So, What are coil recommendations. What are ya'll running. Really don't want to get stranded somewhere on the road again!
  7. M

    why am I blowing up ignition coils?

    73 351 2V, Mostly stock except for Summit 600cfm carb, Eldebrock performer intake and Mallory Unilite Dist. Replaced ignition module in dist. last year. Few months later had to replace the Accel coil - it had cracked and was shorting out. Was on the car when I got it 3-4 years ago. Same thing...
  8. M

    Subframe connectors on a vert

    Wish I had seen the post earlier. I have a set of these subframe connectors, never installed, that I would sell for $125 plus shipping. Also, to complete the handling package, I have some lightly used 1" drop front 600# springs that I would sell for $40 plus shipping. also have a new, never...
  9. M

    Classic Auto Air Question

    I installed what was supposed to be a "Perfect Fit" system in my 73 vert with factory air. My kit does not use any of the factory brackets or pulleys. It came with a compressor mount that bolted to the front of the driver side head, which I kind of liked because it moved the compressor from...
  10. M

    Crank Balancer disaster

    OK, yesterday I replaced the A/C and alternator belts on my car. Backed it into the driveway and ran it for a while at various RPMs and loads to seat the belts so that i could re-tension if needed. Blipped the throttle twice pretty hard and heard a loud bang under the hood followed by a pretty...
  11. M

    steering vibration

    I'm going in a different direction. When I bought my 73  there was a terrible vibration that I could only feel thru the steering wheel when within a certain speed range. Actually felt like the steering wheel would "wobble" back and forth, especially when cold. After going through all the motions...
  12. M

    Rust Free???

    This may be one of those "Don't look a gift horse in the mouth" questions but I have to ask. How plausible is it to have a 1973 convertible that spent 35 years in the eastern Maryland/Washington, DC area and then another 10 years in coastal Florida/Gulf of Mexico area to be "rust free"? When I...
  13. M

    That antenna is tall and it's in the way.

    My car has had a power antenna installed. Baseplate/fender attachment looks original and not very expensive.
  14. M

    Surprises from owner history/repairs

    When I purchased our 73 H code convertible almost 3 years ago I was given a 3-ring binder supposedly containing maintenance and repair records. I never looked at it until last week. Opening the book you find color printouts and pictures from an internet for sale ad dated 9/2006. The car was...
  15. M

    Need radiator help

    That would be great! Just let me know how much and how to order them from you. I assume they will come with original used rubber inserts also. I only need the 1 larger one but if you only sell as a pair thats OK.
Back
Top