Looking to replace front spoiler on my 71 Mach1. The old spoiler I installed back in the 80's had slotted holes that allow for adjustment when installing. Any help would be appreciated.
Sorry it took so long to get back to you. Turns out the WHITE wire that goes to a keyed connection came off. FCC fuel pump now working. FYI ....first I ran a jumper direct off battery to hot side of FCC (pump) and it worked just fine. White wire was the problem. Thanks for your feedback Don...
Thank you your help. I found the staples. Will start removing them. Thought clamping new part with c clamp or small vice grips to hold in place when drilling holes. If all goes well I'll add photos as I progress.
I am also getting ready to replace beltline on interior door panel. How do you remove it from the panel ? Is it glued or stapled to panel ? I have the replacement parts. Thanks for any input. I saw a video on Pony Parts website. they said staple it. I don't see any indication that it is stapled.
It turns out that all I needed to do is put the key in and turn to ON and all is good once again. Shifting through all shift positions. Thanks again for your input earlier.
Thanks to both Mjlan and Don for your input. I will check the detent. Will check to make sure the transmission and lever are in neutral. Making me think maybe the transmission was in DRIVE not NEUTRAL.
Will get back to you soon.
Thanks again
Thanks for response Kilgon,
A little history about shifter. Until about seven months ago shifter movement was very loose and sloppy. An old plastic bushing was replaced and everything was working perfect again. Shifting through all positions smoothly.
Last couple weeks have been reinstalling...
Think they should be renamed Look Cool Lights. The real reason I'm replying ....need the correct bulb number or sometimes called trade name. I can't seem to find anybody that knows the answer. Maybe you could look at one of your bulbs and give me a reply back .......much appreciate your help...
I am also getting ready to install Drip Assembly in week or so. I really appreciate the help from Carolina Mountain Mustang. I also have a Jim Osborn Reproduction of Body Assembly Manual for 1971-1972 Mustang. It states to use (ESB-M2G150-A) Adhesive the entire length of Retainer between...