Recent content by Régis

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    Noob question about arrow on piston

    Very interesting. Thank you for this amount of information. So if i buy aftermarket pistons( very standard as Sealed power pistons), there will be no pin offset? This is a stock engine so i would like new pistons as the original ones.
  2. R

    Noob question about arrow on piston

    Oh OK. That's fine. Thank you.
  3. R

    Noob question about arrow on piston

    Hi guys, I couldn't find the answer ,here or anywhere else, for a simple question : what does the arrow mark on the piston head of my 351C mean? I'm rebuilding the engine but I forgot to take a picture when I disassembled it ... I prefer to ask the question before having a disaster at the...
  4. R

    4r70w is going out TKO500 is going in :-)

    Very nice! Could you tell me how many splines do you have on the entry shaft?
  5. R

    Clutch disc replacement

    OK Thanks . It's a good information for me.
  6. R

    Clutch disc replacement

    Hi guys, My clutch disc is home made to fit a manual gearbox ZF S5-18/3 ( 22 splines) with 351C 1970. I think the disc is for 302 engine ( diameter is 10"). So i cannot just buy a new disc , the disc need a relining( hope this is the right word). For that, i need to know the thickness of a...
  7. R

    Cylinder head torque specifications

    Ok so ARP specs! thank you !
  8. R

    Cylinder head torque specifications

    Hi guys! Just one question before doing a mistake... Engine is 351C 1970 ( stock). i have new ARP bolts for cylinder head. Do i use Ford torque specifications or ARP specifications for reassembly? May be a newbie question but i have a huge doubt.... Thanks for your answer. Régis
  9. R

    Rear wheel bearing removal

    Thank you all for the answers!  So it's not easy ... i'll take it to a machinist...
  10. R

    Rear wheel bearing removal

    Hi guys, I try to remove the rear wheel bearing from the axle shaft...whithout success( even if i heat the bearing). I don't have the specific tool described in the shop manuals...Any ideas? Thanks!
  11. R

    rear suspensions Mach 1 1973

    Thank you Steve for your answer. So this is to improve stability Under hard acceleration. Nice!
  12. R

    rear suspensions Mach 1 1973

    Hi guys, Here is a picture of the rear suspensions. the rear left suspension is mounted behind the rear axle and the rear right suspension is mounted before the rear axle. I know this is correct for other car but never see that on mustang 1973...Is it to improve suspension for racing?? Thank you
  13. R

    Inside 351C 1970

    Nice !! thank you ! I'm glad this is normal!
Back
Top