Vinnie

Been on here for awhile, but never added pictures of my car. When I was about 3 years old I told my parents I wanted a Mustang. They...

OK, slightly different question then. I created a rectangular panel, curved in one direction. Like so: It needs to get a little...

Hi Rich, mine rides and handles very well with only minor tweaks. People often ask how i have set up the suspension and are surprised...

A slip roll will give you the section you're looking for. Any metal fabrication shop should have one.

Those are quite complex shapes. There are lots of things I’d like to train on but I’m limited on time…

Hey guys, With my english wheel I tend to always get curves in 2 directions. But sometimes I only need 1, like in the included pic...

@Kilgon It's gonna take a while before I can do that. I have a sh...t load of things to go thru before and I have less time avail than...

time for a little update... Took a while because I had limited time for the 71 and what I was doing wasn't really "forum worth". So...

Looks great buddy! All the time consuming test fitting and shaping and again test fitting etc pays off in the end! Also really like the...

You are doing lot of very good work. Perhaps a side job as a welder! Chuck

Alrighty, time to start patching this @#$*! Got one done, it went like this: Got the crown in with my new English wheel...

Daisy is their cousin. You guys need to watch some reruns! :)

....that the Dukes of Hazzard isnt real US history. :whistle: I really thought it was a documentary. 😖 This is shocking, the Earth...

I should not have mentioned fixing holes... This weekend I ripped off the vinyl top (everybody who ever removed the vinyl prolly knows...

I wonder if there’s a deluxe rimblow degree wheel