Soliciting Advice/Lessons Learned for Subframe Connector Install

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Sep 3, 2015
Messages
1,056
Reaction score
338
Location
AZ
My Car
1972 Mach 1
1971 Ranchero
I'm prepping to install a set of Global West subframe connectors. Looking for input from any of you that have subframe connectors or have installed them. My biggest concern is that the chassis isn't as true as it could be and once I weld, it pretty much locked in. I have good lines on the doors, so it seems pretty straight, but I haven't broken out the trammel and checked it. I'm supporting it under the front tires and on jack stands under the rear axle. I've consistently read that having the weight supported by the tires is a must.

Thanks in advance for your input.
 
Yes, weight on the wheels (or axle, as you have) is the right way to do this. You may want to make sure you're on a level surface and your jack stands maintain the car with that level surface, i.e., car is parallel in the horizontal plane to what it would be if on the ground.
Once it's all positioned check your shut lines on all panels, open and close the doors to make sure there is no stress on the unibody different than when it's on the ground. At this point you should be good to position the connectors and weld them in.
 
I installed mine on a level floor, I put jack stands under the rear axle, but I did put the front up supported at the the fore most part of the subframe, because I couldn't get under the car without jacking it up, Tried the doors to make sure all was good. Car drives great with no issues. And is very rigid. Good luck!!
 
Yesterday I practiced some vertical uphill with 3/16 on top of 10ga. Partway into the job, I found that the rear frame rails are only 16ga! Now I'm concerned about welding such thick cuff to the relatively thin frame rail. That's a big no-no for anything that flexes...to abruptly change the stiffness. If it doesn't flex, it shouldn't be an issue.

Have any of you using the Global West connectors experienced cracking near the welds? I'm more concerned about the rear, but interested in either front or rear cracking.
 
Got my connectors installed and went for a test drive. I've read comments from people saying they feel a difference. What should I be looking for, in terms of differences? About all I can say is that it does the 1-legged burnout easier....further highlighting the need for a limited slip differential.
 
I noticed better ride quality and much less "wind-up" in the chassis on hard acceleration. That is for my Cougar,no connectors on my Mach1. The connectors have been on the Cougar since the late 1980s, no cracking. Chuck
 
Thanks for asking this question. I have a pair of subframe connectors I need to get installed in my vert
 
Back
Top