Search results

7173Mustangs.com

Help Support 7173Mustangs.com:

  1. A

    TMI 1-Piece Headliner

    I'm wondering if anybody has installed the TMI 1-Piece Headliner yet? http://www.tmiproducts.com/mustang/browse-by-vehicle/classic-1964-1973/1971-73/1971-73-mustang-sportsroof-1-piece-headliner-corinthian-vinyl.html Apparently this upgrade gives an extra couple of inches in headroom plus can...
  2. A

    Fastback vs Coupe

    Asking those that have driven both the fastback and coupe shapes 1) is the head height the same/similar? 2) is the visibility better in the coupe? Wondering how the two styles compare to drive...
  3. A

    Identify these wires/plugs?

    What are the three plugs in the engine bay by the firewall used for? I see the 4 pin is for the neutral safety switch The 3 pin is for the engine feed I'm guessing one of the plugs is for the light in the auto transmission shifter housing (not sure which one though). Maybe one of these is...
  4. A

    Fuel vapor separator

    Does anyone know what the foam type material is inside the fuel vapor separator that sits atop the fuel tank? I have found that if I install the unit without the foam when walking up to the car you can notice a petrol smell around the car. The other unit with the foam (and cleaned up since...
  5. A

    Steering column firewall seal

    I am in the process of refurbishing my steering column and I cannot recall which way the firewall seal for a manual transmission goes? I've had a look through the shop manuals/online/etc but not able to find a picture that clearly shows this. I've attached a picture of what I have loosely...
  6. A

    351c - Identify this part??

    Hello, wondering if anyone can identify exactly what the part I have circled in orange in the picture is? I know this block came from a 73 Mach 1 that had a manual transmission. I'm thinking the clutch is connected in some way here at a guess? The car had previously been crashed I recall seeing...
  7. A

    Rear Glass Install Question...

    Hi, I am about to get my rear glass panel installed back into my 71 Mach 1 and decided to get this particular job "professionally" done. I have read a few posts on this site and have noticed that foam should be installed before placing the glass onto the car. I mentioned this to the installer...
  8. A

    Brake Booster upgrade...

    My Mach 1 has no brake booster (drum brakes front and rear). I was thinking of adding something like this: http://www.cjponyparts.com/master-power-brake-booster-conversion-kit-1971-1973/p/BBCK4/ Wondering if anyone has tried this upgrade? I am planning on upgrading the front to disc brakes also.
  9. A

    NON AC Foam Seal Kit

    I took a chance and purchased one of these kits on eBay that has the foam seals for a NON AC 1971 Torino Heater box: http://www.ebay.com/itm/290881433535?ru=http%3A%2F%2Fwww.ebay.com%2Fsch%2Fi.html%3F_from%3DR40%26ghostText%3D%26_sacat%3D0%26_nkw%3D290881433535%26_rdc%3D1 If the link above...
  10. A

    Original Steel Wheel Color

    I am wanting to repaint my original 14x7 steel wheels. I will be using the "Ford Motor Company" dog dish caps with original trim rings. I had thought about painting the wheels black but read somewhere they may have been painted Dark Argent. Wondering if anyone knows what color/paint code they...
  11. A

    Deluxe Door Panels

    Hello, I'm sure this has been asked before! How can I be certain from the Marti report if my car was ordered with the deluxe or standard door panels? My 72 convertible has the deluxe panels currently but I don't see anything on the Marti report that suggests it was ordered that way. The current...
  12. A

    Front grille brackets

    Hi, I'm after the two brackets that go between the hood latch bracket and front grille (Mach 1 type). I don't need the rest of the latch assembly. I can easily clean them up so I'm not concerned too much on the condition. Kind Regards, Kerry...
  13. A

    Rear Seat Part Location...

    I was wondering if somebody could point out where the brackets in the photo go exactly? I originally pulled these parts from the rear seat area (71 Mach 1, non fold down seat) but forgot to take any photos. Now that I'm putting it back together I'm not 100% sure these go. Any help/photo would...
  14. A

    Heater Control Cable Lock Nut???

    Hello, does anybody know of a modern substitute for the lock nuts/caps that go on the two heater control cables to help prevent the cables from slipping off? I've had attached a photo for reference and circled the area I am referring to.
  15. A

    Boss 351 Carburetor

    Hello, I'm after a Boss 351 carburetor (D1ZF-ZA) restored/unrestored. I know these are rare! If you have the real deal I am keen to talk.
  16. A

    Drivers windshield wiper misses...

    Hello, since I've had my car (71 Mach 1 Fastback) the driver's window wiper misses a section of the front windshield each time it passes, ie. the blade doesn't contact the glass. The wiper blade at the top and bottom touches the windshield and wipes away the water but the center part of the...
  17. A

    Boss Crankshaft Pulley

    I am after a Crankshaft Pulley (with Power Steering option) for a Boss 351 engine rebuild. The stamped number on the pulley should read D1ZE-6312-BA (Ford part number D0ZZ-6A312-A). Alternatively does anyone know of a good substitute? I've heard D2OE-6312-BA may work. Many thanks...
Top