Search results

Drive was loud. Overall good, it will be a lot more comfortable with glass and intetior.

Drove the car about 40 miles. Blue tape was to avoid rock chips.

I ended up purchasing Craig’s parts. detritusmaximus tail panel and trim are up for grabs. I am trying not to give in to my inner parts hoarder and buy both! Thanks for everyone who responded.

Pm sent. I’d like em.

Recaro expert M seats

Just sent you a PM for pics and price. Thanks!

Found! Thanks guys. WTB- tail panel trim with or without the tail panel itself. Must be OEM. Prefer bright- but oxidized okay. Must be 100% straight- no dings. For the textured steel tail panel- not the honeycomb.

Edelmann or gates.

Get a kit or two and go for it. You probably can’t make it leak more than it is!

The seals are retained by snap rings. Personally I’d get a good pitman arm puller and do the work on a bench. There is no packing, nothing can be tightened to reduce the leak- just need new seals, of which there are more than one on both shafts. Look here to get an idea of what is involved to...

I don’t have a protractor handy but the angle matches the rear valance. I had the same idea that tips could be added later.

That is what I did- but I am not trying to keep my car 100% correct.

Rear bumper on. Blackened the stainless caps on the carriage bolts with some Sculpt Nouveau transitional stainless black.

I got the front bumper on, the tail lights and trunk seal.

Welcome!

This mornings project was the repop grill. Close, but different enough in a few ways. 1) The headlight trim ring (door) fastener hole is too big. 2) The holes for the trim clips were pretty wonky and not fully cut. Ended up securing the trim clips with epoxy. Lesson learned with a repop...

A comparison pic of before and after…

Single bank

Installed the front and rear valance, along with my front splitter and fender extensions. So far so good. The front bumper will be the same darker color as the front extensions. Front bumper fillers were grey and I dyed them black.

I have flipped through the body assembly manual twice. I can’t seem to find a diagram showing the front fender extensions. Anyone have a reference? Trying to figure out if any sort of seal or goo should be used