Search results

Oops there it is ::thumb:: :wrench:

Not my cars one with a aftermarket hood and one with a oem hood. You need to start with adding the fender shims as per the factory. 2nd You need to insure the hinges have no play are in excellent condition. I couldn't get my hood aligned using new aftermarket hinges or my sloppy originals so I...

You know can make traces out of the silver foil aluminum tape or copper tape http://www.amazon.com/Copper-Conductive-Adhesive-Width-Length/dp/B009KB86BU/ref=sr_1_3/190-4965896-9992150?ie=UTF8&qid=1460585124&sr=8-3&keywords=conductive+tape+copper

A few things to add when doing interior repair--As said dawn is the first step--then wash with comet and soft scrub sponge--then denatured alcohol--then spi waterborne wax and grease remover--dawn again--then S.E.M. soap with a grey scuff pad then wax and grease before final finishing the above...

U-Pol Makes good stuff been using their products for quite some time, good value for the money !

So, so, true ! :goodpost:

Your not going to get full vacuum on a new motor that hasn't broken in seated the rings-Check back after you put a few thousand miles on it

For someone like your self with no welding experience the new panel structural adhesives are a great option for doing some small patch work as a matter of fact even as a pro I sometimes utilize this method sometimes you can't justify welding in a patch and the associated work required to do it...

Not sure about the other trannys but the 4r70w I did in conjunction with the baumann controller gives you a lot more than a 4th gear too..multiple modes with the flip of a switch- paddle shifter ready and a lot more. basically your in the same price range as the GV unit maybe a touch more or...

Easy out is as pointed out ..I would use a propane torch on low to heat the area before you attempt removal -You could weld a nut on or a bolt on whats left get on it right after welding as the heat will make it easier to remove. personally I would attempt welding a nut on since it looks like...

Fresh warm air from the top and exhaust is actually out the plenum silver box (built from 1x2 frame and covered with foam sheathing panels hot glued to the frame) then 24" black tube hooked up to a panel that screws onto my entry exterior door inside door frame. The fans were used commercial...

Looks good ::thumb:: Noticed your fan setup did you see pictures of the booth I made ? Works amazing almost boarder line you don't a mask thats how well it extracts.

The best way to wash these cars or any cars for that matter is to do your normal wash routine and heres the key DRY WITH A LEAF BLOWER gets all the water out of the nooks and crannys behind the moldings etc. I've been doing it for years plus if you perfect the finish (polished waxed ) you don't...

Heres how I addressed this issue obviously applies to a car your going to paint. They all came this way from the factory.

I didn't cut them worked out starting from ends towards the middle.

How old are they ? I had the same Issue with a set I purchased about 4 years ago. I recently purchased a set for the green 72 they fit perfect --What you have to do is screw in both sides and work a little at a time side to side working your way to the middle of the door.

Due to the fact that so many of these cars have had aprons and other front structural pieces replaced over the years one size isn't going to fit all. Your going to need to have the front bar adjustable on one side via a turnbuckle arrangement. Take a look at the 2004 350z they come from the...

Watching to many of those flip a car T.V. shows

Nice :coolphotos: Dragnet and Adam-12

Check out my vid ---shows how to remove the springs