Search results

Maybe the spindles are large taper and you put small taper tie rod ends into them?

If for some reason you still have any of this in the summer I will be driving past on a road trip. Not that I “need” any of it, but scratch free coupe glass would be nice.

I put it together about 3 or 4 years ago with a new heater core and a factory evap. I don’t recall there being any problems. Just took some patience and putty. One thing I do recall was that I had every metal bit of my old heater box powdercoated. While I had to use most of the bits one of...

I have the ACP box. Much better (tougher material) than OEM.

I ended up buying the repop ones off hotrod31 on eBay. Nice copies.

We’ve got to cut back how much Vice Grip Garage you watch… There are some halfway decent powered subs out there. Personally I listen to my 351C when driving my car. In my van I have a couple 8” Alpine type R subs in .6cuft ported boxes. One observation I have had is that in order to overcome...

That is the best fiberglass hood fitment I have seen.

Spray it with some phosphoric acid. (Concrete etch). Available at the home box stores. Read the directions.

Is there a replacement available? That looks like you have a clock. Might try a headlight polishing kit.

Any reason you don’t want to stay with a Saginaw?

@kevken1959 could you post some more pics of it? Is there a shoulder inside that prevents using a longer Allen key to drive it from the outside? If your 3/4” driver is too short to reach through it you could run to your local hardware store and grab a coupler nut for allthread that is long...

Contacted Lares, and they are unwilling to make a run of couplers using the 3/4” single D upper half from a 219 and a lower half 13/16” 36 spline from a 201. They already have the parts, just need to be assembled in a different combo. Unfortunately whoever they have running their support chat...

Snapshot from the video.

Regarding the Lares 219. We have one member that states it works, and a couple that state it doesn’t. Can anyone show dimensions and or photos of what is/isn’t working with the 219? The power steering box input shaft should be a 13/16” 36 spline (if you were to count the splines that were...

I’d take pics of it from all angles and send them off to Tim. I’d be surprised if he does not make it right.

Agreed. He sent out a bad run of parts.

Assuming you bought that from TMeyer it looks like they screwed up on that batch. Like you said it should be broached for the Allen key on the big end.

I’m in CA- PM me the info

My question was more of a suggestion that you go with whatever platform your buddies have. For me I went Holley, and I probably have $300 wrapped up in jets, air bleeds, metering blocks, gaskets, accelerator pumps and cams, and squirters. I don’t know squat about Edelbrock carbs, but if you...

Before you commit to that platform do you have any buddies that run Holley?