Search results

Bought my 73 when 17, still have it, now I'm 57.

I cannot open your link, but try NPD look up concourse hoses.

If the belts are still not lining up, let's measure your spacer behind the alternator and bolt length. The front bracket merely hold the front firm. The belt alignment is dictated by what's behind the alternator. Also are the other pulleys and brackets factory for

It goes in like the other plugs. Freeze it first to shrink it. It's half as deep as the other plugs so don't drive it in too far, just clear the edge.

I checked TMI site and saw the panels you referred to. I took their part number and searched it. It came up in many places. One was CJpony the panels with that number were approximately $475 a set or so. I think the TMI site is advertising full retail pricing for vendor protection issues. I used...

Could it be a rear cam plug you are seeking?

I've used TMI and Distinctive with no issues.

Are you running r12? A 40° evaporator should probably have 50-60° coming from the vents.

You can buy it at Ace hardware for about $4.99. I've been buying it for years.

You sound so sure. The sun is warming the car, the car is warming the air. He has to block the sun.

I would think that you could use your bezel to hold the aftermarket gauges. I'm guessing the gauge face will conflict with the bezel cluster face.

All the wife could say was " Oh God, how the heck did that happen?"

The AC sounds like a good idea. I think that you need to block the sun also.

I make staples out if stainless steel welding wire, drill two small holes every five inches or so. Push the staples through the twin holes. Fold them over tight on the inside. Paint the exposed flat side with black paint. I've seen many cars at shows with the rivits. If you use any screws make...

I've used welding leads for this. I see old ones in the scrap yard all the time. Buy them for the dirty copper price.

Marti also has the original window sticker. That has been a must have.

I looked at your pictures again and must ask if you are spraying in a plastic outdoor spray booth? The greenhouse effect will the answers.

It doesn't matter if the crank turns. Just match up to the key, where ever it ends up. You could probably do it with rad in place, depends on your puller and what you are using to get torque on it. I would remove it just for ease. Not sure about the replacement part, I've only used OEM there.

I might have a free one if you cover shipping. Send a picture of the needed part. I parted two coupes last year. Is this piece about four inches wide with a metal edge on the bottom.?

Very good catch. Neat picture.