Search results

351c, 2v, mallory dizzy., new coil. I have a no start no spark condition. Car started two weeks ago. Here's a description from a different forum that seems to describe three actions at start. "When you turn the key to start... 1)Power runs from the ignition switch thru the NSS to the S...

Hello, 351c 2bbl H code. Saw some conflicting info on the following so was hoping someone could clarify for me. Pulled my carburetor and noticed that there were two gaskets. No spacer so here's my questions. Did all 71, 72, 73's come with carb spacers or are there a certain engine/carb...

For those that have done this swap or are fairly knowledgeable about it (particularly if an FMX was coming out) what is typically done with the lockout rod. Is there a way to connect it to the new trans? Is there and after market product used to resolve this issue? Or, do most not worry about...

I don't currently have A/C but may plan on installing it (351c 2v w/ original intake). Need some clarification on the original heater hose connections. What were the original ports where the A/C heater hoses connected. I'm guessing right front intake port and top port on water pump (labeled as...

Think I mistakenly deleted the original post but that's a different story for a different time. Pretty much have my trans installed except for speedo and driveshaft. Will work on speedo today. Got to get u joints for drive shaft. The one hang up I have is the range selector . When in the...

Does anyone recognize what type of ignition coil this is (make, model, spec) or how I might go about identifying it?

Ok, so I disconnected the fuse block from the harness and then put it back together and now I have no spark but am not really sure if the two are related. Checked connectors for resistance wire and all seems to be good. Coil is good and solenoid is being energized cause engine turns over but...

Have the following parts if anyone is interested. These are off of a 71 coupe. Original parts: LCA UCA Exhaust Manifold Tie Rods Front anti Sway Bar Steering Idler Arm Rear Spring shackles Gauge Lens Dog Dish Hub Caps Styled wheel trim ring Front Shocks Used parts: rear shocks New...

Selling the following parts. NEW ITEMS Battery Tray Taillight panel USED ITEMS (original to car) LCA UCA Exhaust Manifolds Tie rods Front anti-sway bar Steering idler arm Rear spring shackles Gauge lense Dog dish hub caps PM if interested. Wheel trim rings Front shocks Rear shocks

Evening, 1) On the emissions canister what is the function of the cap on the center vent? Does the canister function properly without the cap? If I needed one where could I get it? 2)What is the wire in the second picture? I think it goes to the a/c condenser but not really sure. Thanks...

How much would you pay for this stang? Engine/Trans - tired 302 with C4. It runs. A/C parts/brackets missing. Probably needs overhaul or replacement. Rust - Typical rust issues but overall fair condition. Trunk is rusted out. Lower rear quarter panels rusted out. Paint - chipping/peeling...

Was jacking my 71 by the pumpkin to get some underside cleaning done. As I was jacking noticed that the rear axle seemed to be hanging lower on the right side. As I let it down noticed that the right side settled flush into the jack stand while the left side settled with about 1/3 inch clearance...

Are these holes for alignment of some sort? [attachment=28154][attachment=28155]

[attachment=27899]What is this panel/part to the left of the torque box in this picture and is it available anywhere. The issue I'm having is the hole at the bottom of the panel where one of the bottom fender bolts inserts is missing (that part of the panel is torn off). I want to do a proper...