I've seen this more than once in a post where someone has some unknown part and multiple replies come back as to what it is and where it can be found.
That is soooo GREAT to see that members are so helpful and sharing of info! I just felt that I had to say something! My $.02
I went with the 235/60 - 15 for front and rear. Mainly because I wanted a full size spare and could swap tires front / rear.
As it was, for some reason, I had an issue with a replacement front wheel and as a result I had to swap it with a rear tire/wheel. Couldnt have done that if they were...
Unfortunately I think we are going to see a lot of this as many of us older car owners age out. I've also seen some car shows discontinued because of no one to run them. People gravitate to restomods or rice burners.
Just to many Fast and Furious movies as well as Grand Theft Auto videos.
Well I dont know if this will help but maybe its something that will work for you.
A few years ago I searched all over the interwebs looking for a dealer emblem for my 71 Mach 1 i.e. Dealer Name / Location. Not finding anything I came across this company that makes one of a kind badges/emblems...
Here is the procedure powersteering.com recommends:
Filling Procedure
Fill the pump’s reservoir (tires on the ground)
Start the engine for a few seconds and turn it off (do not turn the steering wheel.) Check and refill the reservoir.
Repeat Step 3 until the reservoir remains full. (If you...
It looks like you have the part on the right.
If you wanted to replace it, since they seem to be not found, you could use the one on the left, which NPD sells. I believe they typically have 3 vacuum connections.
I believe I've seen caps similar to these. The issue is, there appears to be two different heights, shorter vs taller. Ads just seem to mention the 2 1/8 size diameter and not the height.
I dont know if I would trust anything sold by Scott Drake. I recently needed a new center cap for a Magnum 500 wheel. The original center caps have a prong type way of attaching to the wheel whereas the repro ones ( typical ) being sold use a 4 screw and cap type of mounting to the wheel.
Of...
I havent checked under the car yet but since I have the starter relay on the fender I'm assuming that there is not one on the starter itself? Some mention offset so what is that referring to?
Would anyone happen to have a part number for starter motor for a 71 351c that I can refer to?
Thanks...
The other day I went to start the car ( 71 Mcode Mach )and it seemed like the starter and motor didnt sync correctly. There was just a noise without turning over the engine although its hard to describe. It started fine on the next crank. Something like this hasnt happened in the past.
Just...
It should come out when you take the banjo bolt off or, if its sitting in the carb, grab it (tweezers etc) and pull it out. Its a fine mesh so you clean it or order new ones from Holley.
Does that Holley carb have a bonjo bolt at the fuel inlet? If it does and you remove that bolt, there is another little filter screen that is inside that inlet. Maybe check that screen also.
Sheriff, Thanks for your thoughts on this issue. I checked the gauge NPT threads that were screwed into the NPT T fitting and there is a section that was not covered by the Permatex paste. That most likely has to be the issue since the 'problem' went away once I removed the gauge.
Although I've...