Search results

I have never seen Grabber Lime on a Grande before, looks good. Nice Job!

It is pretty cool to know my car was good enough for this and just plain lucky that someone from Revell was at the car show. The process of the 3D scanning was very interesting but the spray they used did not wash off as expected. I was told they had done two of Chip Foose's cars but his cars...

I had a similar problem. My drain plug had a plastic washer and it always had a small leak. I replaced with a copper crush washer but that leaked worse. A new drain plug that was supposed to fit was too small. I ended up getting a washer from Autozone that had a rubber insert and I am now drip...

I have been waiting to post this when the model was officially available. My car was 3D scanned for this model. I was approached at a car show in Raceway Woods (site of Meadowdale Raceway in the 60's) in Carpentersville, Il in the fall of 2019. The car was scanned in August 2020 so it has taken...

Welcome from Illinois. Good luck with the restoration.

Welcome from Illinois, nice looking car.

Welcome from Illinois, good luck with the car.

Welcome from Illinois. Nice looking car. I found my car in northern Minnesota.

I have done this and it does a great job of protecting the paint. If done properly, you would be hard pressed to notice it. That being said stripes and decals are a problem, you either need to put the PPF around them or do them separately, otherwise you get an air gap where the paint transitions...

That looks like a nice buy.

It's just a typo, that is a $7,500 car.

This is a really nice looking car but seems expensive...

Welcome! Nice car and a great story.

Welcome from Dundee IL

That's a great looking Sprint! Welcome

My car had Flowmaster mufflers when I bought it and have been very satisfied with the sound. That being said I am not sure how much the differ from a stock muffler as far as sound and flow.

Another good idea, thanks!

Thanks kmash! I had never heard of Phoenix but they certainly make a lot of different decals. I reached out to them, hopefully they will respond. 

A few of the points of the decals around the front wheel well have started to peel back, has anyone had any luck gluing small parts of the decal back to paint. If so what type of glue do you recommend?

Ok, I will check in to that it seems fine since I am certainly not trying to do a Concours car. Thanks.