Search results

71 mustang tilt steering column. fit 71-73 mustang,i have the gear washer and clip for the ignition lock is included, i couldn’t line it up right so i when back to a fix column, tilt work ok

can you tell me which one is right for disc/ drum power brake setup, if neither can you show the right diagram 

was changing my ignition lock and a gear and washer came out , not sure how to put it back in, also i don’t see a snap ring that a diagram show

not sure if i got the rag joint on right 

when i turn the wiper off they stop in the up position how do i change this, it’s is a new wiper motor 

when i turn the wiper off they stop in the up position how do i change this, it’s is a new wiper motor 

brought a original trunk light, is it’s installed correctly and how do a Mercury switch work?

73 mustang wiring harness non-ac only one wire was cut, rear defrost wire and speedometer cable 

installing a 71 steering tilt in my 73 fastback, changing ignition switch and turn signal to 73, and changing the rag joint and steering box. do need anything else?  and do install the rag joint on the column or  steering box, using Lares 219 rag joint 

i’m about to change out my non-tilt for a Tilt steering column, other than disconnecting wiring and the 3 bolts on the floor what else do i need to do, was also thinking about changing the rag joint and power steering box too. i been looking for a write up 

I keep about pushing something so I can take the ignition out, but I’m not sure where to push

In the Process of Installed my parking brake, I’m looking for a picture of the route the cable go and how they are Connect, I’ve already seen a print, I’m looking for a pic

my sail panels isn't lined up,  can I see a picture of one close up, more of the end by the fastback back window

how do I tighten the remote mirror bezel, I have the bezel and washer but I cant seem to get the bezel to catch the thread on the mirror on a standard panel

     how do i unscrew the knob so I  can replace it with a new one, I try holding the outside and unscrewing the knob but all  its do is turn

do anyone got a picture on where the 3 dash clips goes

ŁI went to change my seat latch and found out bad just can’t meet at 73 Mustang seat

In the process of putting my  73 mustang climate control non AC unit together do anybody have a picture on how the cables run from the switch to the duct work

is there a gasket or something that go here, if so what the part name or where can I get it from

in the progress of rebuilding my rear axle and want make sure I have the right parts before I take them to press on