Search results

thru the fuel pump hole to see the timing chain marks on a 351c ?

What do you guys think about a pump and pully from CJ Pony ..Review said that Pully fits loosely applied by hand ???

on my 73 Mach

for these engine fender support brackets ,maybe a smaller ones ?? these are to big and are in the way of changing my spark plugs.

any body might know Zoom in on the sticker

for my 73 Mach,,, is the one's CJ Pony have good?

Here's the history 1973 351c rebuilt in 1990 ,,drove around till about 2004 (tires are stamped 2003 with very little wear) probably sat in a garage till i got it in 2018 new gas tank 15gal gas high test..timing set at 16* i set the carb adjustments too,, starts up and runs fine (but first time...

if your car was made before 5-14-73 has a different  column key switch it is CJ Pony part num HW1543 after 5-14-73 its HW1544 i hope CJ Pony puts that on there web site and not go thru sending 2 of the wrong switches and then the wright one to me

a electric water and manual oil gage on a 73 351 c

Best place to get one ,,I never did this kind before ,,any tips also?

it looks like id have to glue it on,,, you'll have to open it i still hadn't figered that out yet thumbnail (1).jfif thumbnail.jfif

i got a 73 Q code Mach 1...

are they original or repops and are the 70  different from 71s ?

star trek into darkness enterprise vs vengeance on the right side front of block is a plate ticked on their

Does the valve covers on the CJ Pony site that says (289,302,351w ) would these valve covers fit the Cleveland engine many say 351w on their site very little say Cleveland,,,,another thing the 45000 flame thrower coil does it send 12v all the time to the distributor???

engine turns over quick and starts idles rough quickly accelerates (standing still) pops a little ,,new plugs,cap points wires fuel pump,,no EGR valve  set air and fuel mix on carb still runs rough What would be a next step

Ok here when I got the car 73 mach 351c it would only start by turning the key on and jumping the solenoid but i had to tap the solenoid with it jumped it would start and run good ,, so I thought maybe the neutral safety switch is bad and the solenoid so I changed the solenoid and now nothing...

I worked in a gas station as a helper Mechanic Two girls came in it was raining and asked me to help them get home they couldn't drive their car cause it was in bad condition so the Boss let me go and drive them home the car barely started, tires were bald,Bad front end, bad breaks, trans...

the vacuum lines and all the is needed from the plenum to the manifold  I installing it on an engine that didn't have it to begin I got a sheet that shows I need a "choke line?"and a "Metal sensor"a "solenod" I don't know were to start I got a kit from C J,,, well here's a pic of my engine and...

a Cobra jet 351 and a red 4 barr 351?