Search results

Thank you very much. Happy motoring!

I have a 71 mach1 with a 351 4v, c6 and 9 inch rear. I am looking to replace the drivers side axle. Would the axle be a 28 spline or 31? Any suggestions on where to get one at a decent price would be appreciated. Thanks Rick

All the aftermarket pieces are very soft. I recommend that you get black window sealer and glue it in place. Trust me, you will never install it without bending it. I hope you prove me wrong but I tried many times, even took it to local glass place . Good luck.

My right directional signal light inside the car does not always work. The signals outside work fine. I figure its a loose bulb , they were changed to led about 5 years ago. I am trying to get the bezel off and get to the bulb. It is fighting me and the problem is it is hitting the steering...

What do you mean finished? That car is like new. Didn't you read the description.

My wife's 65 convertible is pictured in the readers album section. They have me listed as having a 71 convertible but I actually have a Mach 1. Glad to be in it. I had sent the picture in at least 6 months ago and forgot about it so it was a surprise.

I had scratches on my rear and side windows and I only made them worse trying to polish them out. I took the car to a pro glass place and they could not get them out. I replaced the side rear window and I put louvers on the rear window because it has a rear defrost setup and I did not want to...

I replaced mine years ago without taking the windows out. It still looks good.

You guys are the best. I found a broken vacuum cap at the back of the carb. The best way to do it was with the propane torch. The carb cleaner is ok but it will take the paint off the motor. Thanks again

The choke is working fine. I checked the vacuum and it was over 15 at the carb and over 20 at the manifold. I checked all the lines and everything is holding the vacuum except the ram air which leaks a little. I bypassed it but it did not make a difference. Any other suggestions? Thanks

Thanks for the response. I will let you know how I make out

I have a 71 351 4V with a holley carb. The car has been running great for some time now. I went for a ride yesterday for about 1/2 hour. I stopped the car for about 5 minutes. The car was a little hard to start after the rest but would not idle. It kept stalling. I was able to make it home and...

I paid $100 for one a few years ago on ebay so I don't think the price is out of line. Very hard to find

Do you go to Foxboro Thursdays ?

It is impossible to get the trim on without damaging it. I glued the trim on and its been on for about 3 years now and is fine.

I believe if your lift the car and turn the rear wheel one revolution and count how many revolutions the driveshaft turns you can tell what the ratio is .

I wonder if those are city or highway miles.

I agree and I think the 69 Mach1 is much nicer than the Shelby

Would like to see the camera setup.

That is a different clip. Thanks anyhow