Search results

I put on a new power steering pump using the factory bracket and picked up a Scott Drake Pulley for it. The pulley doesn’t line up. Needs to go on about another inch to line with water pump and main. Any body else have this issue?

I have a 73 Mach 1 Q code with the C6 transmission. A previous owner has done some "interesting" things to this car. I have attached some pictures of the current transmission configuration as well as the parts I think I need. I have the pan currently pulled and looking for some advice. If I...

I have a 351C, can I remove the oil pain to replace the seals without removing the entire engine?

My 73 Mach 1 is missing the "emissions" canister that would normally be on the firewall of the passengers side engine compartment. The vent line has been cut off around the back of the engine. With the vented gas cap is this even needed? What would be some recommended ways to handle this...

Any idea why someone would drill a hole in the rear end???

There are empty clips in the wheel wells both front and back on my 73 Mach 1. Any idea what they are for? Pic attached.

I recently purchased a 73 Mach 1. As I'm sure is usually the case, the more you dig, the more you find. The bushings on the front sway bar were totally gone and the bar itself was very rusted. Easy fix, just replace it. When I go to replace it I can't get the passenger side to line up. As I...

I pulled out the old headliner and I have light rust on interior of roof. Do I need to brush this off or can I just put a rust treatment on it? Looking for recommendations on best way to handle. Exterior paint is good so I need to be careful not to generate any heat or vibration that could...

I have a 73 Mach 1 with the fold down rear seat I'm working on. The trap door is functional but needs some work and adjustment. Can someone post some pics of the trap doors original finish and the sides where the latches clip in to? Looking for pics from trunk side and back seat. Was there...

Looking for a map light for a 73 center console. TIA

Does anyone know what these two connectors are for? They come off the wiring harness near the solenoid. TIA Don

Looking for some serviceable trim panels

Looking for drivers side headliner trim that goes along back side of side window. TIA

I recently picked up a 73 Mach 1 like I had when I was younger. It needs some work and has had some performance upgrades done. Some not so well. If I remember correctly from my first Mach 1 there should be a linkage rod going up to the carb from here. It has a Edelbrock 1407 carb on it.

I have a new restoration project, my first. I pulled up the carpet today and the floor has a lot of surface rust from the insulation. What is the best way to clean this up and treat it before I put down new carpet?

I've got a new project car and some painted the rear interior quarter trim panels very poorly. I'm not sure how they managed to do such a bad job. Any ideas how to salvage? Does anyone have any replacements? I've heard nothing but bad on the aftermarket ones.

I recently purchased this project car and it has some mods done to the engine. It has an Edelbrock 1407 carb and a Torker 351 manifold. Looking for some thoughts and opinions on this setup. I have posted some pics to show the current state. Also looking for any recommend fixes or changes I...

I have a 73 Mach1 and the latches for the trap door are missing. Has anybody found a source or another solution for these? I know you can get the 70 version. What is the primary difference? Can those be modified to work? Thanks for any input.