- Joined
- Mar 7, 2013
- Messages
- 1,281
- Reaction score
- 29
- Location
- New Jersey
- My Car
- 1973 Mustang Convertible (Mach I Tribute)
I just picked up a 73 Original Ford tooling dash pad from CJ Pony and not sure if it's correct.
As you can see in pic 1 and 3 there are metal clips attached to the pad with holes in them.
In pic #4 there is a cut out with NO metal clip in it (Should there be a metal clip attached?)
In pic #2 it looks as if it was started to be cut out but not complete (is this ok or should this have been cut out with a metal clip?)
In pic # 5 (which is he opposite side of pic #1) there is no cut out with metal clip (should there be?)
Is this correct?
As you can see in pic 1 and 3 there are metal clips attached to the pad with holes in them.
In pic #4 there is a cut out with NO metal clip in it (Should there be a metal clip attached?)
In pic #2 it looks as if it was started to be cut out but not complete (is this ok or should this have been cut out with a metal clip?)
In pic # 5 (which is he opposite side of pic #1) there is no cut out with metal clip (should there be?)
Is this correct?