- Joined
- May 19, 2021
- Messages
- 1,359
- Reaction score
- 952
- Location
- Fort Mohave, AZ & So Cal (Upland)
- My Car
- 73 Grande will undergo three phase build process. Phase 1 is complete (driver). Phase 2 is interior/exterior restoration. Phase 3 is ++ performance.
Does anyone have experience in bending a non-stainless 3/8” steel line? I’m running a new one on the drivers side, and while I have my nifty Harbor Frieght tube bender, will I be able to make 90 degree bends on that size? I’ve bent my own lines for years, just can’t remember if I’ve done it that big; it’s been awhile. I don’t have any to practice on, why I’m asking. Thank you.