71 Mach1(Trans Am) 2" nose drop

[71Rustang]

Hello,more progress.I had to take the first two pipes I built and change the bottom halves of both of them to move them to the inside collector.Because I found out that I had no nice way of getting pipes 7 and 8 into the inside collector that I would be happy with. So after that I moved on to mocking up 7 and 8. I built 8 first since 7 depends on how I ran 8 ,#5 is 41'',6is 41 1/8'' and 8 is 40 15/16'',now we're getting somewhere,on to 7...........

 

[PoFoMoCo]

That’s just ridiculous! You are truly making a piece of art.

 

[71Rustang]

That’s just ridiculous! You are truly making a piece of art.

Thank you

 

[71Rustang]

Here's number 7 at 41 1/4''. I need to order more pipe and bends to do the passenger side.The picture with all the pipes is without the steering box installed.

 

[71Rustang]

Hi everyone,It's been a little while,I've been busy with the passenger side header. Just like the drivers side all for pipes are at 41 inches+/- a 1/16 or an 1/8''. Much more room on this side of course and I could see what I was building the whole length of each pipe. So this side isn't as compact as the other side because they don't have to be. I have plenty of room around a full size starter,so any mini I choose will fit without any problems. I did make the choice to run the pipes over each other where they go into the collector so I can still remove the bell without taking of the exhaust. I'm taking a short break to swap a 4 speed into my 76 F150,then I'll be back at the tail pipes and tunneling the rear floor.

 

[PoFoMoCo]

Can't wait to see the progress!