- Joined
- Jan 17, 2015
- Messages
- 1,772
- Reaction score
- 611
- Location
- California
- My Car
- 71' Grande project.
71’ 351C car.
I can’t figure out how the heck the factory engine harness lays.
Looking at the 72 diagram it seems like it should follow the drivers side valve cover.
The “gotcha” seems to be the oil pressure wire which has to go to the sender in the center rear of the valley. The short white wire with red trace is that wire.
It almost appears like the harness crossed the rear of the engine and went forward on the passenger side valve cover.
Any help is appreciated (but good help is really appreciated!)
I can’t figure out how the heck the factory engine harness lays.
Looking at the 72 diagram it seems like it should follow the drivers side valve cover.
The “gotcha” seems to be the oil pressure wire which has to go to the sender in the center rear of the valley. The short white wire with red trace is that wire.
It almost appears like the harness crossed the rear of the engine and went forward on the passenger side valve cover.
Any help is appreciated (but good help is really appreciated!)