Door panel holes not lining up?

[Scubaman]

On my ‘73 convertible I’m having problems attaching a reproduction door panel. The holes in the panel do not line up with the holes in the door by 1-1.5 inches. Ordered door panel clips from NPD and they are too short. They are L clips and they fit into the holes fine but are not long enough to match up with the holes. Does anyone have any clever ideas to attach the panels?

 

[MikeGriese]

New holes?

 

[73MustangCoupe]

I discovered the same thing yesterday when I started to install my door panels.

 

[Cjmach1]

On my ‘73 convertible I’m having problems attaching a reproduction door panel. The holes in the panel do not line up with the holes in the door by 1-1.5 inches. Ordered door panel clips from NPD and they are too short. They are L clips and they fit into the holes fine but are not long enough to match up with the holes. Does anyone have any clever ideas to attach the panels?

What I did was used a small rotary drill with a bit and slightly made the hole that the clip fits in a bit bigger to whatever side the hole on the door lines up to.worked well for me

 

[73CobraJet]

Be sure to check the clip alignment on the door panel. The loop end on door panel goes only one way to correctly position the clips. Had this on several Mustangs.

 

[Cjmach1]

Be sure to check the clip alignment on the door panel. The loop end on door panel goes only one way to correctly position the clips. Had this on several Mustangs.

Your right,the repo panels are slightly off . Not all holes just a few. That were like I was saying on the repo door panels I just lined up and made the black piece that the clip fits in a bit bigger to which way it had to line up and it worked great. No issues

 

[Kilgon]

Here is a little write up I did. Had to make quit a few adjustments to get them to fit nicely. I had to also make some minor adjustments for the door handles.

Deluxe door panels

Seen several post on after market door panels from supplier x and how poorly they fit. When I first got my mustang and before I knew of this forum or all the suppliers out there, I ordered a complete interior kit from a company and it wasn't Ohio Mustang or NPD. Even though I knew it would...

7173mustangs.com

I also purchased these and use them to fill the hole behind the window crank since it was off center after making the adjustment. I just drilled and painted the black. Worked out well.

https://www.amazon.com/gp/product/B087C23SZL/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&th=1

 

[70cobrascj]

Which door panels did you purchase?
I purchased the newer improved and more expensive ones from NPD and they fit pretty well.
The problem I see is that the panel is thicker than the originals and it’s going to be tough to install the drivers side remote mirror knob. I haven’t finished the install yet as I took the interior back out while I do other things to the car.