ignition switch lock gear

Copestang

Well-known member
Joined
May 11, 2017
Messages
132
Reaction score
1
Location
Michigan
My Car
1973 Mach 1
was changing my ignition lock and a gear and washer came out , not sure how to put it back in, also i don’t see a snap ring that a diagram show

2E16290C-BDF9-4070-AC7C-AB23FA360411.png

 
Last edited by a moderator:

Don C

Fords Forever
Joined
Jan 1, 2012
Messages
7,894
Reaction score
686
Location
Springfield, OR
My Car
1971 Mustang Sportroof M code
The snap ring holds the gear and washer in place inside the casting, so they don't pull or fall out when the key lock is removed.

 

Copestang

Well-known member
Joined
May 11, 2017
Messages
132
Reaction score
1
Location
Michigan
My Car
1973 Mach 1
ok thanks, so i install the gear washer and snap ring first and the snap is going lock them down? is there a specific way if’s give in.  

i’ve this order a snap ring from ebay 

 
Last edited by a moderator:

Don C

Fords Forever
Joined
Jan 1, 2012
Messages
7,894
Reaction score
686
Location
Springfield, OR
My Car
1971 Mustang Sportroof M code
Last edited by a moderator:

BryanWalker

New member
Joined
Nov 27, 2021
Messages
1
Reaction score
0
This information is really very helpful, i would use it and save cost from contacting an auto locksmith to repair ignition lock.

 
Top