Stripping off the Ameron (Imron) paint

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

#1dadsmach

Member
Joined
Feb 25, 2018
Messages
5
Reaction score
0
Location
california
My Car
I have a 1973 Mach 1 with a 351 Cobra Windstar on sore engine I think it is 351 though my dad passed away in September and I inherited it and he loved this car I am restoring it for him it is quite a job
[url=https://ibb.co/hqPLXc][img]https://preview.ibb.co/f2OsdH/1519551813785270959743.jpg[/img][/url]

[url=https://imgbb.com/]tiny image hosting[/url]
Hey I'm new here but I'm up on myself so I really want to share it with you pictures of this project that I'm doing on my dad's car was my car now but I got plans for it check out the pictures trying to take off the Ameron paint is of huge pain in the butt this thing has not been running for like 15 years and I got a good mechanic over here he got it running I somehow got it in my garage and now I'm trying to take off this paint which is not like paint it is like way thicker than paint





IMG_20180225_013446.jpg

 
that would be clear coat, paint, and primer................

Ameron?

 
Last edited by a moderator:
If you mean Imron paint that stuff is tough. Sanding will take forever so you may want to consider aircraft paint stripper. Others here may have more experience or suggestions with this. I think DuPont made it. I have a friend who shot his 66 fastback with that back in the 80's and it looked great.

And welcome from Illinois btw!

 
Last edited by a moderator:
I also think you are referring to Imron paint. Very tough to remove but aircraft stripper will do it. Messy but effective. Post some more pictures and data. There are alot of helpful folks here who can save you on the learning curve, and money. Welcome from Albuquerque, NM Ed

 
If you use aircraft remover brush it one direction, you can lay plastic over it to make it more effective. Wear gloves and a respirator in a well ventilated area. Keep a wet rag handy cause it burns like hell. Wear Glasses also.

 
Usually with this kind of composites, after sitting there for years, I would not expect much chemical reactions.

I'd go for mechanical removal using rotating brushes/tool. Not too aggressive for the surrounding bare metal.

I'd also remove the windshield moldings while at it, you may damage them while sanding and chances are high there is corrosion under them.

Welcome from the Netherlands

 
Last edited by a moderator:
Welcome from Germany

Juergen

 
#1dadsmach,

What part of Cali do you live?

Go to Fun Stuff at top of this page and pin your location in the Members Map.

 
omg i barely look at all these responses and I'm so happy right now you guys like made my night I didn't think anyone was going to respond so I am going to post more pictures now

 

Latest posts

Back
Top