T-Piece on Motorcraft 4300D

7173Mustangs.com

Help Support 7173Mustangs.com:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

RobertS

New member
Joined
Jun 20, 2021
Messages
3
Reaction score
0
Hello,

I still have a Motorcraft 4300D on my 351 and would like to have all the hose routing and related connections as original as possible.

There is a plastic T-piece on the rear side. On the 90° connection the tube for the hot-air-choke is connected (points with yellow spots on the photo need to be connected with each other).

Clean air is taken from the inside of the air cleaner, heated up within the intake manifold and drawn into the hot-air-choke housing.

Does anybody know where to connect the straight leg of the T-piece (red arrow). If not, can you please refer me to a source who could tell 1972_4300D T-Type connector.jpgthis?

Thank you very much for your feedback in advance,

Robert

 
I believe that one goes to the choke pulloff and the other goes to the bi-metal switch in the air cleaner that controls the flapper in the inlet.

Please go to the Introduction section of the forum and introduce yourself and car. We like pictures.

 
Hi Don,

thank you for your answer. The choke-pulloff and the vacuum actuator on the snorkel need to connect to straight manifold vacuum. That port with the plastic T-piece is open to atmosphere. I have been searching for this info for a long time and found only vacuum hose routing diagrams like the attached. The T-piece and the related tubing is missing. 

I actually have a Pantera. Nobody could help me yet so I thought it would a good idea to contact the 71-73 Mustang specialists. Not sure if you still like me to upload pictures..

Thanks,

Robert

Vac72.jpg

 
This is my original routing of those hoses on my 73 Q Code ( California car).

F9C35B73-A234-46BD-8389-FF8070E6ADF9.jpeg

 
Thank you very much ! This is the first time I see the straight leg of this T-piece connected. I would like to replicate this on my carb. Can you please let me know where the tubing with the yellow arrow connects ?

Thanks again,

Robert

T-piece 4300D connected.jpg

 
Thank you very much ! This is the first time I see the straight leg of this T-piece connected. I would like to replicate this on my carb. Can you please let me know where the tubing with the yellow arrow connects ?

Thanks again,

Robert

View attachment 52554
If you look close enough, you can see it is connected to manifold vacuum via the three (four?) way manifold connection. Pretty straight forward. Keep in mind this is a 73 351 4300D carb and factory installed California emission set up. 

 
Last edited by a moderator:
Back
Top